We present an energetically autonomous robotic tadpole that uses a single membrane component for both electrical energy generation and propulsive actuation. The coupling of this small bio-inspired power source to a bio-inspired actuator demonstrates the first generation design for an energetically autonomous swimming robot consisting of a single membrane. An ionic polymer metal composite (IPMC)...

The goal of this simulation study is to examine, in a sheet of myocardium, the contribution of anode and cathode break phenomena in terminating a spiral wave reentry by the de brillation shock. The tissue is represented as a homogeneous bidomain with unequal anisotropy ratios. Two case studies are presented in this article: tissue that can electroporate at high levels of transmembrane potential...

This study compared the difference in microbial community and power generation capacity of air-cathode MFCs enriched under anode aerobic and anaerobic conditions. Results showed that MFCs successfully started with continuous air inputting to anode chamber. The aerobic enriched MFC produced comparable and even more electricity with the fuels of acetate, glucose and ethanol compared to the anaero...

A novel lighting device, flat electron emission lamp (FEEL), has been developed for generating planar light. The mechanism of FEEL is different from the mainstream techniques for lighting and display. The basic idea for FEEL is, for the first time, to integrate the discharge mechanisms of fluorescent lamp at cathode with the cathodoluminescent effect at anode. In that the electrons are induced ...

Ion back-bombardment is the dominant mechanism that limits the operating lifetime of DC high voltage GaAs photoelectron guns. In this work, an electrically isolated anode electrode was used to distinguish the QE damage contributions of ions produced within the cathode/anode gap and those produced downstream of the anode. This new anode design provides a means to suppress QE decay due to ionized...

This paper demonstrates the enhanced capability of single polarity charge sensing, the 3-dimensional position sensing technique, developed at the University of Michigan and previously successfully demonstrated on CdZnTe detectors, to improve the spectroscopic performance of HgI2 and to extend its range for spectrometry to an unprecedented thickness of 10 mm. Energy resolutions of close to 1% FW...

We report a methodology for enhancing the mass transfer at the anode electrode of sediment microbial fuel cells (SMFCs), by employing a fabric baffle to create a separate water-layer for installing the anode electrode in sediment. The maximum power in an SMFC with the anode installed in the separate water-layer (SMFC-wFB) was improved by factor of 6.6 compared to an SMFC having the anode embedd...

Carbon nanofibers modified graphite fibers (CNFs/GF) composite electrode was prepared for anode in high substrate concentration microbial fuel cells. Electrochemical tests showed that the CNFs/GF anode generated a peak current density of 2.42 mA cm(-2) at a low acetate concentration of 20 mM, which was 54% higher than that from bare GF. Increase of the acetate concentration to 80 mM, in which t...

*Correspondence: Fanglin Chen, Department of Mechanical Engineering, University of South Carolina, 300 Main Street, Columbia, SC 29208, USA e-mail: [email protected] Solid oxide fuel cells (SOFCs) can convert chemical energy from the fuel directly to electrical energy with high efficiency and fuel flexibility. Ni-based cermets have been the most widely adopted anode for SOFCs. However, the conv...

Impedance changes of the anode, cathode and solution were examined for an air-cathode microbial fuel cell (MFC) under varying conditions. An MFC inoculated with a pre-enriched microbial culture resulted in a startup time of less than ten days. Over this period, the anode impedance decreased below the cathode impedance, suggesting a cathode-limited power output. Increasing the anode flow rate di...