a digital look-up table adaptive predistortion technique using a six-port receiver for power amplifier linearization is presented. the system is designed in ka-band for a dvb-s2 satellite link. we use a six-port receiver at the linearizationloop in place of classic heterodyne receivers. the six-port receiver is implemented by the use of passive microwavecircuits and detector diodes. this approa...

A low-power 435-MHz single-ended low-noise amplifier was implemented in a 0.35-μm silicon on insulator (SOI) CMOS technology. The SOI CMOS LNA has a simulated noise figure of 0.6 dB, input 1-dB compression point of –12.5 dBm, input thirdorder intercept point of –5 dBm, and small-signal gain of 22 dB. Total power dissipation is 10 mW from a 2.5-V supply. LNA chip area is 1.4 mm x 0.58 mm. Due to...

A new bandpass amplifier which performs both functions of low-noise amplifier (LNA) and bandpass filter (BPF) is proposed for the application of 900-MHz RF front-end in wireless receivers. In the proposed amplifier, the positive-feedback Q-enhancement technique is used to overcome the low-gain lowQ characteristics of the CMOS tuned amplifier. The Millercapacitance tuning scheme is used to compe...

A new bandpass amplifier which performs both functions of low-noise amplifier (LNA) and bandpass filter (BPF) is proposed for the application of 900-MHz RF front-end in wireless receivers. In the proposed amplifier, the positive-feedback Q-enhancement technique is used to overcome the low-gain lowQ characteristics of the CMOS tuned amplifier. The Millercapacitance tuning scheme is used to compe...

In this paper we have describes the design of current mode instrumentation amplifier (CMIA) for bio-signal Acquisition system. The current mode instrumentation amplifier technology is based on voltage mode operational amplifier (op amp) power supply current sensing technique. There are two design challenges of this topology. First one is the Op amp mismatch and second is precise current mirrors...

A dual-path amplifier topology with dual-loop parallel compensation technique is proposed for low-power three-stage amplifiers. By using two parallel high-speed paths for high-frequency signal propagation, there is no passive capacitive feedback network loaded at the amplifier output. Both the bandwidth and slew rate are thus significantly improved. Implemented in a 0.6m CMOS process, the propo...

–This paper presents a highly linear Operational Transconductance Amplifier (OTA) that combines two linearization techniques, one with adaptive biasing of differential pairs and second with resistive source degeneration. The Operational Transconductance Amplifier has ±0.9v power supply. Operational Transconductance Amplifier has been simulated with TANNER 0.18μm CMOS technology in Tspice. The s...

A new CMOS fully differential bandpass amplifier (BPA) based on the structure of a transresistance (Rm) amplifier and capacitor is proposed and analysed. In this design, the Rm amplifier is realised by a simple inverter with tunable shunt-shunt feedback MOS resistor and tunable negative resistance realised by crosscoupled MOS transistors in parallel with a current source. The capacitor is in se...

Absrracl A highly linear CMOS RF amplifier and mixer circuits adopting MOSFET transconductance linearization bv linearlv suoemosine several commonTherefore it is very important to linearize MOSFET transconductance for both RF amplifier and mixer circuits. We have shown that multide eated transistor (MGTR) 111 ~ _ . source FET transistors in parallel, combined with some additional circuit techni...