This paper aims at experimental and numerical investigation of springback behavior of sheet metals during Lbending process with emphasis on Stribeck-type friction modeling. The coefficient of friction in Stribeck curve depends on sliding velocity and contact pressure. The springback behavior of mild steel and aluminum alloy 6022-T4 sheets was studied experimentally and using numerical simulatio...

The present work is focused on the numerical analysis of forced convection in curved tubes. The study was performed by integrating the continuity, momentum and energy equations within Comsol Multiphysics 4.2a environment. The analysis was carried out under the assumptions of incompressible Newtonian, constant properties fluid and of periodically fully developed laminar flow. For the thermal pro...

Series Elastic Actuators have linear springs intentionally placed in series between the motor and actuator output. The spring strain is measured to get an accurate estimate of force. Despite using a transmission to achieve high force/mass and high power/mass, the spring allows for good force control, high force fidelity, minimum impedance, and large dynamic range. A second order linear actuator...

This work presents a numerical analysis of entropy generation in Γ-Shaped enclosure that was submitted to the natural convection process using a simple thermal lattice Boltzmann method (TLBM) with the Boussinesq approximation.  A 2D thermal lattice Boltzmann method with 9 velocities, D2Q9, is used to solve the thermal flow problem. The simulations are performed at a constant Prandtl number (Pr ...

Cylindrical telescopic crowns belong to bolt dentures, because their adhesion strength is based on the friction force. The magnitude of static and slide friction forces depends on the strain within the contact area and properties of materials employed. Friction force value between telescope elements declines in the first phase of wearing period and, subsequently, maintains particular constant v...

Friction coefficients are measured in ultrahigh vacuum using a tungsten carbide tribopin against thin films of sodium chloride and potassium iodide deposited onto clean iron. It is found, in accordance with previous measurements for potassium chloride on iron, that the friction coefficient falls from an initial value of 2 for the clean iron surface to a minimum value after a few tens of Ångstro...

Analytical and numerical modeling of the nonlinear interaction of shear wave with a frictional interface is presented. The system studied is composed of two homogeneous and isotropic elastic solids, brought into frictional contact by remote normal compression. A shear wave, either time harmonic or a narrow band pulse, is incident normal to the interface and propagates through the contact. Two f...

One of the surface energy balance components, the sensible heat flux, can easily be described for modelling and remote sensing purposes by means of the thermal roughness length (zot). This roughness length is usually expressed relative to the roughness length for wind speed (zou): kB−1 = ln(zou/zot). In the past, the kB−1 factor has been taken as a constant having a value of ca. 2 in the case o...

PACS. 82.20K-Potential energy surfaces for chemical reactions. PACS. 71.45N-Calculations of total electronic binding energy. PACS. 68.65-Layer structures, intercalation compolU1ds and superlattices: growth, structure and non-electronic properties. PACS. 61.16D-Electron microscopy determinations (inc. scanning tunnelling microscopy methods). Abstract.-We investigate the microscopic mechanism of ...

We have studied friction and dissipation in single and bilayer graphene films grown epitaxially on SiC. The friction on SiC is greatly reduced by a single layer of graphene and reduced by another factor of 2 on bilayer graphene. The friction contrast between single and bilayer graphene arises from a dramatic difference in electron-phonon coupling, which we discovered by means of angle-resolved ...