A significant part of all types measurements performed in modern industry and science are gas, liquid or other media. This is important because there many processes where you need to clearly control the parameters environment - pressure, density, etc. The object research MEMS gas density sensors. subject eliminate shortcomings existing similar systems, increase accuracy measurement range measur...

Relativistically broadened and redshifted 6.4 -- 6.9 keV iron K lines are observed from many accretion powered objects, including X-ray binaries active galactic nuclei (AGN). Existence of gas close to the central engine implies large radiation intensities correspondingly densities if is remain partially ionized. Simple estimates indicate that high needed allow survival against ionization. These...

this paper is a density functional theory (dft) calculation of intramolecular proton transfer (ipt) in 6-hydroxypicolinic acid (6hpa, 6-hydroxypyridine-2-carboxylic acid) tautomeric forms. the transition state for the enol-to-keto transition is reported in the gas phase and in four different solvents. the planar and non-planar dimer forms of 6hpa keto and enol, respectively, were also studied i...

We report measurements of excess electron mobility in dense Argon gas at the two temperatures T = 152.15 and 162.30 K, fairly close to the critical one (Tc = 150.7 K), as a function of the gas density N up to 14 atoms·nm−3 (Nc = 8.08 atoms·nm−3). For the first time a maximum of the zero-field density-normalized mobility μ0N has been observed at the same density where it was detected in liquid A...

in many processes polymeric foams can be produced by using chemical or physical blowing agents. in this work for polyethylene foam production, the chemical blowing agents and compression moulding process were employed. at first, by using dsc diagram of two polyethylene grades, a suitable polyethylene grade was selected for foam production and then we discuss about blowing agent critical percent...

Boron included aluminium nitride (B-AlN) thin films were synthesized on silicon (Si) substrates through chemical vapour deposition ( CVD ) at 773 K (500 °C). tert-buthylamine (tBuNH2) solution was used as nitrogen source and delivered through gas bubbler. B-AlN thin films were prepared on Si-100 substrates by varying gas mixture ratio of three precursors. The structural properties of the films ...

The gas-assisted gravity drainage (GAGD) process is designed and practiced based on gravity drainage idea and uses the advantage of density difference between injected CO2 and reservoir oil. In this work, one of Iran western oilfields was selected as a case study and a sector model was simulated based on its rock and fluid properties. The pressure of CO2 gas injection was close to the MMP of th...

Indium (1at %) doped ZnO and ZnO nanoparticles have been synthesized via sol gel method. The structural characters of the synthesized nanoparticles have been studied by X-ray diffraction pattern (XRD), scanning electron microscopy (SEM) and energy-dispersiveX-ray spectroscopy (EDX). From synthesized nanopowders a tablet was prepared by using the isostatic pressing and then sintered at ...

UNLABELLED The measurement of ventilation distribution is currently performed using inhaled tracer gases for multiple breath inhalation studies or imaging techniques to quantify spatial gas distribution. Most tracer gases used for these studies have properties different from that of air. The effect of gas density on regional ventilation distribution has not been studied. This study aimed to mea...

A 100 MeV electron laser wakefield injector based on a sub-millimeter gas cell is presented. The gas cell, used mainly to overcome the density inhomogeneity associated with gas jets, is capable of yielding a homogeneous plasma source with densities less than 2 x 10 cm. Sharp step plasma density boundaries were obtained by using the laser to drill the gas cell pinholes as small as 100 μm in diam...