Grinding is one of the most widely employed manufacturing processes when accurate finishing of workpieces is required. In order to investigate the effect of processing parameters to grinding performance, soft computing methods constitute a reliable and economical alternative to other simulation methods, such as the Finite Element Method (FEM). In this study, a comparison between classical Artif...

This paper revisited some wheel–workpiece interaction problems in surface grinding including the profile of heat flux and the variation of the wheel’s elastic modulus. A method of using an optical microscope and a CCD camera was applied to capture the depth and width of the heated zone, the details of the temperature field and the stability of the heat flux. It was found that the heat flux in u...

A suitable grinding fineness and flow-sheet could potentially reduce the mechanical entrainment of gangue minerals in the flotation process of microcrystalline graphite. In this study, the suitable grinding fineness of a commercial graphite ore was estimated by mineralogy analysis and laboratory grind-flotation tests. The target grind size of this ore should be 92% passing 74 μm based on the mi...

Abstract: The specific rate of breakage is one of the most important factors in evaluation of grinding process especially in ball mill. In this article the effect of ball size and feed size on selection function were investigated using batch grinding circuit on two-iron ore anomaly (B, C) from sangan mine in north of Iran. Eight different monosize fractions were prepared between 2000 and 50...

This study investigates the influence of some chemical additives such as methanol, ethanol, sodium oleat, chloroform and sodium hexametaphosphate (SHMP) on the dry fine grinding of calcite (X50= 33 µm) using a stirred media mill. The experiments were carried out by a batch operation, and the change in colour properties (Ry, whiteness and yellowness) of calcite powder. The results showed that th...

Grinding and polishing are widely used surface finish operations for a variety of precision and delicate component of ceramics, such as silicon wafers and gauges. However, the formation and evaluation of the subsurface damage induced have not been investigated, although subsurface damage is extremely important to the quality of the products. Grinding and polishing are usually carried out by a s...

Introduction: Mars exhibits a wide variety of landforms that are indicative of ductile flow, ranging from the viscous creep of ice-rich permafrost [1] to the glaciation of thick Martian ice sheets [2] to the surface mobility of thin debris flows [3]. All of these flow features probably contain significant amounts of dust, which for example will likely be present throughout the impact-disrupted ...

The aim of this study was to determine a suitable amount of grinding of a flexural test specimen for clinical evaluation of dental ceramics. Three dental ceramics (Crys-Cera, OCC and IPS Empress Cosmo) were selected. Five types of bar-shaped patterns were prepared for a three-point bending test, and four types of disk-shaped patterns for a biaxial flexural test. Ceramic specimens were fabricate...

-A vermiculite (Libby, Montana) sample obtained from the Zonolite company contained mostly coarse-grained separates with only 8.7 per cent clay. The 2-50 #m fraction was used for particle-size reduction studies by wet and dry grinding, and size-fractionated into < 2, 2-5, 5-20 and 20--50 #m sizes. About 18 per cent of the sample was attrited to clay after 64 hr of wet grinding, but as much as 5...

The purpose of this paper is to understand the combined effect of thermal and mechanical plastic deformation on residual stresses in ground components. The interactions between a grinding wheel and a workpiece, including both thermal and mechanical interaction, are simulated by triangular surface loads moving with the table speed of grinding. Cooling is modelled by a uniform convection over the...