This paper presents design and practical implementation of single-phase inverter based on selective harmonic elimination-pulse width modulation (SHE-PWM) technique. Microcontroller mega type Arduino used as a controller for producing the gate pulses. The optimized switching angles determination results in wide range output voltage. Depending number angles, lower order harmonics (LOHs) can be el...

This paper presents an h-infinity robust loop shaping control and LCL filter to mitigate the effects of harmonic currents in photovoltaic system integrated with grid. To eliminate negative filter, this work applied notch active damping. Existing methods for elimination were reviewed. Proportional integral control, fuzzy logic are presented. The grid current was analyzed all controllers voltage ...

A Neural Network based AC-AC voltage restorer is proposed for voltage sags and PWM type active power filter is used for voltage harmonics compensation and EMI reduction. The objective is to apply the neural network switching control technique to the AC-AC voltage restorer to reduce time delays during the switching conditions and switching losses. The aim of the IGBTs used in the AC-AC voltage r...

Nonlinear and unbalance loads in three phase networks create harmonics and losses. Active and passive filters are used for elimination or reduction of these effects. Passive filters have some limitations. For example, they are designed only for a specific frequency and they may cause to resonance in the network at the point of common coupling. The other drawback of a passive filter is that the ...

In this paper, a harmonic elimination and suppression scheme for a dual-inverter-fed open-end winding induction motor drive is presented. Two isolated dc-link sources with voltage ratio of approximately 1 : 0.366 are required for the present drive. These two isolated dc links feeding two inverters to drive the openend winding induction motor eliminate the triplen harmonic currents from the moto...

Proliferation of nonlinear loads in power systems has increased harmonic pollution and deteriorated power quality. Not required to have prior knowledge of existing harmonics, Prony analysis detects frequencies, magnitudes, phases, and especially damping factors of exponential decaying or growing transient harmonics. In this paper, Prony analysis is implemented to supervise power system transien...

Usually a STATCOM is installed to support power system networks that have a poor power factor and often poor voltage regulation. It is based on a power electronics voltagesource converter. Various PWM techniques make selective harmonic elimination possible, which effectively control the harmonic content of voltage source converters. The distribution systems have to supply unbalanced nonlinear l...

High-voltage cascaded H-bridge multilevel (CHBML) inverters usually include many isolated dc voltage sources. Some dc source faults result in a drop in the dc voltage, thereby leading to unequal cell dc voltages. On the other hand, the differences in cell dc source parameters result in unequal dc voltages too. At present, riding through the faults of dc sources and operating under the condition...

This article has been accepted for publication in a future issue of this journal, but has not been fully edited. Content may change prior to final publication. Abstract—In this paper, SHM (Selective Harmonic Mitigation) and SHE (Selective Harmonic Elimination) modulation techniques have been combined to produce appropriate pulses for four-leg three-level NPC (Neutral Point Clamped) inverter. In...

This paper presents the analysis of series active power filter for reactive power compensation, load balancing, harmonic elimination, and neutral current eradication in three-phase four-wire power systems. Generally, the three-phase four-wire system is widely employed in distributing electric energy to several office building and manufacturing plants. In such systems, the third harmonic and its...