1. A calorimeter for the continuous measurement of heat production and heat loss in the human subject, for at least 24 h, is described. The calorimeter operated on the heat-sink principle for direct calorimetry and an open-circuit system for indirect calorimetry. 2. Sensible heat loss was measured using a water-cooled heat exchanger, and the temperature of water entering the heat exchanger was ...

In present work, comparison of three different tube bundles for particular heat exchanger is proposed. Three types are smooth, micro finned and corrugated tubes. Heat exchanger will be designed with smooth tube bundle and simulated. Micro fin and corrugation over tube is applied separately for same heat exchanger in feasible size and simulated for performance. Besides, comparison is done with h...

As the number of transistors increases with new generation of microprocessor chips, the power draw and heat load to dissipate during operation increases. As a result of increasing the heat loads and heat fluxes the Conventional cooling technologies such as fan, heat sinks are unable to absorb and heat transfer excess heat dissipated by these new microprocessor. So, new technologies are needed t...

Heat exchangers are one of the most important devices of mechanical systems in modernsociety. Most industrial processes involve the transfer of heat and more often they requirethe heat transfer process to be controlled. A heat exchanger is the heat exchanged betweentwo media, one being cold and the other being hot. There are different types of heatexchanger, but the type which is widely used in...

This two-part study explores the development and thermal performance of a coiled-tube heat exchanger for hydrogen fuel cell storage systems utilizing High-Pressure Metal Hydride (HPMH). The primary purpose of this heat exchanger is to tackle the large amounts of heat released from the exothermic hydriding reaction that occurs when the hydrogen is charged into the storage vessel and is absorbed ...

Heat exchangers play significant role in refrigeration and air conditioning systems. Ongoing research aims to improve, or at least maintain, the system performance while reducing the size, weight and cost of the heat exchangers. This in turn leads to lower system refrigerant charge and reduced environmental impact. Using heat exchangers with small tube diameters (less than 5 mm) instead of larg...

The paper presents an advanced control strategy that uses the neural network predictive controller and the fuzzy controller in the complex control structure with an auxiliary control variable. The controlled tubular heat exchanger was used for pre-heating of petroleum by hot water. The heat exchanger was modelled as a nonlinear system with interval parametric uncertainty. The set point tracking...

This article reports the evaluation of a Joule-Thomson (JT) cooling system that combines two custom micromachined components-a Si/glass-stack recuperative heat exchanger and a piezoelectrically actuated expansion microvalve. With the microvalve controlling the flow rate, this system can modulate cooling to accommodate varying refrigeration loads. The perforated plate Si/glass heat exchanger is ...

This article presents the results of the experimental runs of a prototype of R744 (CO2) refrigeration system operating in a both air conditioning and heat pump mode when heat rejection is done in supercritical region. The prototype system is sized for a compact car. Data presented are in the limited range of operation. Further optimization and extension of operating range is underway. Test faci...