Determination of the starter torque-speed diagram is a major task in the design or selection of a proper gas turbine starter. In this paper, the maximum power of the MGT-40 gas turbine starter was calculated based on the dynamics of the rotor, start-up logic, and compressor map. In a recent research, the pressure ratio was assumed as a linear function of the rotor speed and the required starter...

A power criterion for selecting the electric motor used in a gas turbine emulator is defined. The power criterion is derived in terms of the ratio of inertias between the gas turbine engine and the electric motor, rotational losses and load torque. The gas turbine emulator allows emulating the speed-torque behavior of a gas turbine engine. Using simulation models, we show that the steady-state ...

In this study, the feasibility of using micro-wind turbines to power wireless sensors on a cable-stayed bridge is comprehensively investigated. To this end, the wind environment around a bridge onto which a turbine is installed is examined, as is the power consumption of a wireless sensor. Feasible alternators and rotors are then carefully selected to make an effective small wind generator (kno...

Renewable energy sources like wind, sun, and hydro are considered as a reliable alternative to the traditional energy sources such as oil, natural gas, or coal. This paper describes modeling and simulations to determine a method for the power performance evaluation of autonomous wind turbine system. A speed control regulator is utilized to control the DC bus voltage. The inverter gate’s signals...

Cavitation is an important problem in hydraulic machines that negatively affects their performance and may cause damages. Cavitation is a phenomenon which manifests itself in the pitting of the metallic surfaces of turbine parts because of the formation of cavities. In the present paper, a brief description of the general features of cavitation phenomenon is given and also discussed about the T...

Traditional wind turbine control algorithms attempt to maximize power capture at low speeds and maintain rated power at high wind speeds. Active power control refers to a mode of operation where the turbine tracks a desired power reference command. Active power control enables wind farms to perform frequency regulation and to provide ancillary services in the energy markets. This paper presents...

Combined Cycle Gas Turbine (CCGT) integrates two cyclesBrayton cycle (Gas Turbine) and Rankine cycle (Steam Turbine) with the objective of increasing overall plant efficiency. In modern gas turbine the temperature of the exhaust gases is in the range of 500 oC to 550 oC. Modern steam power plants have steam temperature in the range of 500 oC to 630 oC. Hence gas turbine exhaust can be utilized ...

The combined cycle power plant is made up of three major systems, the gas turbine engine, the heat recovery steam generator and the steam turbine. Of the major systems the gas turbine engine is a fixed design offered by a manufacturer, and the steam turbine is also a fairly standard design available from a manufacturer, but it may be somewhat customized for the project. In contrast, the heat re...

The short term hydrothermal scheduling (STHTS) is a daily planning proposition in power system operation. The main purpose of hydro thermal generation scheduling is to minimize the overall operation cost and to satisfy the given constraints by scheduling optimally the power outputs of all hydro and thermal units under study periods, given electrical load and limited water resource. This paper p...