A personal communications service/wide-band code division multiple access (PCS/W-CDMA) dual-band monolithic microwave integrated circuit (MMIC) power amplifier with a single-chip MMIC and a single-path output matching network is demonstrated by adopting a newly proposed on-chip linearizer. The linearizer is composed of the base–emitter diode of an active bias transistor and a capacitor to provi...

We describe a Nd:YAG slab laser master oscillator power amplifier (MOPA) system that has been scaled to 104 W of output power at 1064 nm, single transverse mode. The amplifier system consists of rod amplifiers followed by edgeand end-pumped slab amplifiers. The MOPA output of 104 W was 89% fundamental TEM00 spatial mode with less than 3% depolarization. These results are a key milestone in the ...

approved: Andreas Weisshaar In cellular telephones, RF power amplifiers consume a significant part of the total phone current. Reducing the average PA current will extend battery life. In GSM systems the handset is commanded by the base station to transmit at power levels lower than full power much of the time. A Doherty amplifier can be used to improve efficiency at these lower power levels, p...

The RF power amplifier (PA) is one of the critical components in the 802.11 transceivers, and it is expected to provide a suitable output power at a very good gain with high efficiency and linearity. However, present-day telecommunication device technology is not well suited to the requirements of optical data communication. Digital CMOS is the most used technology in RF applications, nowadays;...

Short Abstract—A simplified inverse class F power amplifier (PA) with a voltage second harmonic peaking and third harmonic short operating at 2.14GHz for WCDMA base station applications has been developed. The load network is based on transmission line harmonic traps and provides high impedance at the second and low impedance at the third harmonic to the PA. The PA uses a packaged Silicon LDMOS...

The objective of this research was to design a 2.4 GHz class AB Power Amplifier (PA), with 0.18um Semiconductor Manufacturing International Corporation (SMIC) CMOS technology by using Cadence software, for health care applications. The ultimate goal for such application is to minimize the trade-offs between performance and cost, and between performance and low power consumption design. This pap...

A broadband radial waveguide power amplifier has been designed and fabricated using a spatial power dividing/combining technique. A simple electromagnetic model of this power-dividing/combining structure has been developed. Analysis based on equivalent circuits gives the design formula for perfect power-dividing/ combining circuits. The measured small-signal gain of the eight-device power ampli...

Performance of sense amplifier has considerable impact on the speed of caches used in microprocessors. The small difference in voltage level of bit lines of memory cell is amplified by sense amplifier. voltage mode sense amplifier reduces the power dissipation during read and increases the speed also. This paper describes voltage mode sense amplifier and current mode sense amplifier and compare...