There is an increasing interest in developing Phase Change Memory (PCM) based main memory systems. In order to retain the latency benefits of DRAM, such systems typically have a small DRAM buffer as a part of the main memory. However, for these systems to be widely adopted, limitations of PCM such as low write endurance and expensive writes need to be addressed. In this paper, we propose PCMawa...

Use of a phase change material (PCM)-based heat sink in transient thermal management of plastic quad flat package (QFP) electronic devices was investigated experimentally and numerically. Results show that increased power inputs enhance the melting rate as well as the thermal performance of the PCM-based heat sinks until the PCM is fully melted. A three-dimensional computational fluid dynamics ...

Phase change memory (PCM) is the best candidate device among next generation random access memory technologies. PCM has a potential to replace Flash memory due to non-volatility and in-place programmability, and low power consumption. Even though lifetime of PCM is longer than flash memory, wear leveling is needed because of non-uniformity of storage workload or malicious attack. In this paper,...

A phase change memory (PCM) cell with atomic layer deposition titanium dioxide bottom heating layer is investigated. The crystalline titanium dioxide heating layer promotes the temperature rise in the AlSb3Te layer which causes the reduction in the reset voltage compared to a conventional phase change memory cell. The improvement in thermal efficiency of the PCM cell mainly originates from the ...

Salt hydrates have issues of supercooling when they are utilized as phase change materials (PCMs). In this research, a new method was adopted to prepare a salt hydrate PCM (based on a mixture of calcium chloride dihydrate and calcium chloride anhydrous) as a novel PCM system to reduce the supercooling phenomenon existing in CaCl₂·6H₂O. Six samples with different compositions of CaCl₂ were prepa...

Phase change materials (PCMs) have been used in various fields including the materials of buildings. In this research, mixed shape-stabilized PCMs (Mixed SSPCMs) were prepared by impregnating coconut oil and n-hexadecane into exfoliated graphite nanoplatelets (xGnP) through a vacuum impregnate method. Coconut oil is fatty acid ester PCM which is relatively economical in comparison to other PCMs...

Phase change material (PCM), placed in an exterior wall, alters the temperature profile within the wall and thus influences the heat transport through the wall. This may reduce the net energy transport through the wall via interactions with diurnal temperature swings in the external environment or reduce the electricity needed to meet the net load through the wall by shifting the time of the pe...

Latent heat stored in phase change materials (PCM) can greatly improve energy efficiency indoor heating/cooling applications. This study presents the and methods for formation characterization of a PCM layer latent thermal storage (LHTES) application. Four commercially available PCMs comprising classes organic paraffins non-paraffins were selected Pure water emulsions experimentally investigate...

As the temperature of electronic devices increases, their failure rate increases. That is why electrical devices should be cooled. One of the promising cooling techniques is using Phase Change Materials (PCMs). A new passive temperature management technique, that involves the direct placement of PCMs on the chip, has been explored and developed. PCMs are potential temperature regulators that ca...

This experimental study is intended to explore the heat performance of a novel vacuum tube heat collector with thermal storage. In order to enhance the heat transfer performance, we add radial metal fins to the U-tube which is used as the heat transfer channel of water. Meanwhile, in order to increase the thermal capacity of the heat collector, the heat collector model is designed to be larger ...