During the seismic wave propagation through the crust, the electromagnetic pulse can originate due to MHD conversion in this conductive medium. On the assumption of simple models of seismic wave excitation and attenuation, the problem is reduced to the analysis of a diffusionlike equation for a vector potential function. In this way, we need to change the classical gauge condition. A semianalyt...

In this paper, the electric-discharge machining (EDM) of non-contact seal grooves was studied. Two types of material, namely: tungsten carbide and silicon carbide were tested by EDM due to their hard machining behaviors. The geometry of seal grooves is another reason why grinding or other precision machining processes cannot be applied. Four parameters of EDM processes were studied, namely: ele...

A novel self-induced non-ablative threedimensional fractional FRAC3 method for skin rejuvenation is described. The method utilizes short pulse duration/high peak power density of Nd:YAG Accelera mode laser pulses. The Accelera pulses produce a three-dimensional fractional pattern in the epidermis and dermis, with damage islands located predominantly at the sites of skin imperfections. Thermal m...

The assignment of the distinct peaks observed in the OH stretch lineshape of ice Ih is controversial. Recent two-dimensional infrared spectroscopic measurements provided new data. The spectra are, however, challenging to interpret and here we provide simulations that help overcome experimental issues as thermal signals and finite pulse duration. We find good agreement with experiment and the di...

This study investigates the dry and near-dry electrical discharge machining (EDM) milling to achieve a high material removal rate (MRR) and fine surface finish for roughing and finishing operations, respectively. Dry EDM uses gas and near-dry EDM applies a liquid-gas mixture as the dielectric medium. Experimental studies leading to the selection of oxygen gas and copper electrode for high MRR d...

This paper presents a topical review of the current state of the art in modelling the magnetization of bulk superconductors, including both (RE)BCO (where RE = rare earth or Y) and MgB2 materials. Such modelling is a powerful tool to understand the physical mechanisms of their magnetization, to assist in interpretation of experimental results, and to predict the performance of practical bulk su...

In pulsed Nd:YAG laser welding process, the material melts and solidifies consecutively by a peak high power laser beam. The solidification time in this process is very less as compared to that of conventional welding process. The mode of welding process is governed by the process parameters like laser energy, pulse duration, pulse frequency, power and welding speed. This paper aimed at to exam...

A series of laser joining experiments between polyethylene terephthalate (PET) and aluminium alloy (A5052) were conducted to investigate the effect of anodizing on A5052 surface on dissimilar materials used in joining. In this study, PET/A5052 joints with anodized A5052 surface exhibited greater shear strength compared to PET/A5052 joints without anodizing. The shear strength of the joints was ...

We present spatially and spectrally resolved measurements of light emerging from the focus of an intense 25-fs laser pulse in gaseous media. The pulses are focused inside a chamber backfilled with either argon or air to nominal vacuum intensities of up to 5 3 1015 W/cm2, far in excess of that necessary for ionization. We have recorded spectral-spatial maps for various pressures and pulse energi...

The transition between the transient and the stationary regimes of stimulated Raman scattering is examined computationally for pulses with a sharp initial rise. We find that the transient-regime predictions are useful for times less than T2 regardless of the pulse duration and that the stationary-regime predictions become useful only for times much greater than T2 . © 1996 Optical Society of Am...