This paper presents the design and modeling of DC/DC boost (step-up) converter for Advanced Intelligent Systems using Matlab/Simulink. The steady-state and average-value models for the proposed converter are developed and simulated. This work offers modeling and simulation techniques to analyze and design for an overall efficiency optimization of standard synchronous and asynchronous boost conv...

Abstract – Resonant parametric perturbation (RPP) method is an effective non-feedback method for controlling chaos. In this paper, the above method is applied for the current programmed buck-boost dc-dc converter which exhibits chaotic for wide parameter variations. The different possible operating regimes leading to chaotic operation of the current mode controlled buck-boost converter is discu...

A boost converter which employs a flying-capacitor passive lossless snubber to reduce the losses caused by the reverse-recovery characteristic of the boost rectifier is described. The passive snubber consists of a snubber inductor, two snubber rectifiers, and a snubber capacitor. The losses are reduced by inserting a snubber inductor in the series path of the boost switch and the rectifier to c...

Most mobile equipments use battery as power source. The increasing use of low voltage portable devices and growing requirements of functionalities embedded into such devices. Thus an efficient power management technique is needed for longer battery life for them. Given the highly variable nature of batteries systems often require supply voltages to be both higher and lower than the battery. Thi...

The influence of switching frequency on the low-frequency oscillation in the voltage-controlled buck-boost converter is studied in this paper. Firstly, the mathematical model of this system is derived. And then, a glimpse at the influence of switching frequency on the low-frequency oscillation in this system by MATLAB/Simulink is given. The improved averaged model of the system is established, ...

A novel bidirectional DC-DC converter is presented in this paper. The circuit configuration of the proposed converter is very simple. The proposed converter employs a coupled inductor with same winding turns in the primary and secondary sides. In step-up mode, the primary and secondary windings of the coupled inductor are operated in parallel-charge and series-discharge to achieve high step-up ...

The fly back converter has been widely used for multi outputs due to the simple structure and low cost in low-power applications. This paper presents a new multi output converter. It consists of a half-bridge inverter with boost converter in primary side and a fly back rectifier that is integrated with an auxiliary buck converter in secondary side. The boost converter is used to generate high v...