The applicability of irregular prealloyed Ti-6Al-4V powder for the fabrication of titanium products by pressing and sintering and its employment as a master alloy to obtain the Ti-3Al-2.5V alloy was studied. To this end, the starting powders were characterised by dilatometry, differential thermal analysis and XRD. Green samples were obtained by cold uniaxial pressing, and the evolution of the m...

Hierarchical cellular structures are ubiquitous in nature because of their low-density, high-specific properties, and multifunctionality. Inspired by these systems, we created lightweight ceramic architectures composed of closed-cell porous struts patterned in the form of hexagonal and triangular honeycombs by direct foam writing. The foam ink contains bubbles stabilized by attractive colloidal...

Apart from kernel estimators, there have been quite a few different approaches of “generalized splines” for density estimation. In the present paper,Maximum Penalized Likelihood (mpl) approaches are reviewed. In conclusion, penalizing the log density seems most promising. In my “wp” approach for semi-parametric density estimation, a novel roughness penalty is introduced. It penalizes a relative...

In this research accumulative roll bonding process as sever plastic deformation process was applied up to 8 cycles to produce the ultrafine grain copper. Microstructure of cycle 1, cycle 4 and cycle 8 investigated by TEM images. By analyzing TEM images the grain size measured below 100 nm in cycle 8 and it was with an average grain size of 200 nm. Corrosion resistance of rolled copper stri...

The aim of the present work is to study the effects of the nanostructured WC-20 wt. % (Fe,Co) with different ratios of iron to cobalt on the microstructure and hardness of sintered samples. Furthermore, a sample with a cobalt binder under the same condition was produced for the comparison purposes. The nanocomposite development, after different milling times, has been monitored by means of X-ra...

For regions of partial melt in the lower mantle, both compressional and shear wave velocities decrease monotonically with increasing melt volume fraction. It has been observed that regions close to the core-mantle boundary thought to contain partial melt have a velocity decrement ratio (relative change in shear velocity over relative change of compressional velocity) of about 3. This is certain...