We show that the maximum impedance of the parallel combination of a resistor , R an inductor L and capacitor , C studied in a previous paper can be found analytically, without using calculus. In fact, we show that the maximum impedance of this parallel combination is just the value of the resistor R and occurs when the driving frequency  is equal to 1/ . o LC   These results were only demons...

The novel implementation of the square wave generator with the current mode device of the CMOS second generation differential current conveyor (DCCII) as an active element with the grounded resistor and grounded capacitor has been proposed in this paper. This circuit offers the advantage of electronic tunability of its duty cycle with externally connected resistor, and capacitor. The proposed c...

Thermal noise generated by a hot resistor (resistance R) can, under proper conditions, catalyze heat removal from a cold normal metal (N) in contact with a superconductor (S) via a tunnel barrier (I). Such a NIS junction is reminiscent of Maxwell's demon, rectifying the heat flow. Upon reversal of the temperature gradient between the resistor and the junction, the heat fluxes are reversed: this...

What is the complex impedance of a fully coherent quantum resistance-capacitance (RC) circuit at gigahertz frequencies in which a resistor and a capacitor are connected in series? While Kirchhoff's laws predict addition of capacitor and resistor impedances, we report on observation of a different behavior. The resistance, here associated with charge relaxation, differs from the usual transport ...

Requirements that should be met when determining the regimes of circuits with variable elements are formulated. The interpretation of the variations in the regimes, based on projective geometry, enables adequate expressions for determining and comparing the regimes to be derived. It is proposed to use as the parameters of a generalized equivalent generator of an active two-pole with changeable ...

For small signal analysis a simple change from commonly used tranconductance gm to transresistance rm=1/gm leads to a significant simplification of all equations. Moreover these equations are much easier to memorize since they have a form of resistor ratio for CE (CS) and CB (CG) configurations and the form or resistor divider for CC (CD) configuration. With presented approach most of students ...

− Test of insulation resistance is pre-requisite for leakage effect evaluation in many electrical measurements. Especially high resistance measurement at low working voltage is often required for evaluation of high precision measurement system. The high resistance measurement at low voltage level with portable hand-set is a challenging task. Here we suggest a simple and convenient method to mea...

We demonstrate control of the thermal hysteresis in superconducting constrictions by adding a resistive shunt. In order to prevent thermal relaxation oscillations, the shunt resistor is placed in close vicinity of the constriction, making the inductive current-switching time smaller than the thermal equilibration time. We investigate the current-voltage characteristics of the same constriction ...

We consider the problem of two-point resistance in a resistor network previously studied by one of us (Wu 2004 J. Phys. A: Math. Gen. 37 6653). By formulating the problem differently, we obtain a new expression for the two-point resistance between two arbitrary nodes which is simpler and can be easier to use in practice. We apply the new formulation to the cobweb resistor network to obtain the ...