The stress field at the tip of a crack of a thin plate of elastic material that is broken due to a mode III shear tearing has a universal form with a nonuniversal amplitude, known as the stress intensity factor, which depends on the crack length and the boundary conditions. We present in this paper exact analytic results for this stress intensity factor, thus enriching the small number of exact...

We present a new mechanism--discovered using molecular dynamics simulations--that leads to complete healing of nanocracks. This mechanism relies on the generation of crystal defects known as disclinations by migrating grain boundaries. Crack healing by disclinations does not require any compressive loads applied normal to the crack faces and even occurs under monotonic tensile loading. By closi...

Volume alteration in solid materials is a common cause of material failure. Here we investigate the crack formation in thin elastic layers attached to a substrate. We show that small variations in the volume contraction and substrate restraint can produce widely different crack patterns ranging from spirals to complex hierarchical networks. The networks are formed when there is no prevailing gr...

In this study, the frozen stress photoelastic method was used to investigate the three-dimensional effect on the crack growth behavior in a centrally perforated circular cylinder under internal pressure. The inner surface of the cylinder had a star shape, which consisted of six fins. The specimens were capped at the ends and pressurized internally above critical temperature after real cracks we...

The increasing incidence of military aircraft engine failures that can be traced to high-cycle fatigue (HCF) has prompted a reassessment of the design methodologies for HCF-critical components, such as turbine blades and disks. Because of the high-frequency vibratory loading involved, damage-tolerant design methodologies based on a threshold for no crack growth offer a preferred approach. As im...

A B S T R A C T Effect of microstructure on mixed-mode (mode I ‡ II), high-cycle fatigue thresholds in a Ti-6Al-4V alloy is reported over a range of crack sizes from tens of micrometers to in excess of several millimeters. Specifically, two microstructural conditions were exam-inedÐa fine-grained equiaxed bimodal structure (grain size $20 mm) and a coarser lamellar structure (colony size $500 m...

This article discusses results obtained from a parametric study to analytically evaluate the impingement of a crack at the interface of an environmental barrier coating (EBC) and a monolithic Silicon nitride (Si 3 N 4) layered ceramics substrate. The study establishes a correlation that leads to determine if the crack is arrested or advanced by either penetrating or deflecting along the EBC/sub...

In this study, the phase field model of crack propagation is used to study the dynamic branching instability in the case of inplane loading in two dimensions. Simulation results are in good agreement with theoretical predictions and experimental findings. Namely, the critical speed at which the instability starts is about 0.48cs. They also show that a full 3D approach is needed to fully underst...

The study of brittle or fatigue fracture that involves contact along the crack faces is difficult for several reasons. On the one hand, material data pertaining to the growth of cracks in a compressive environment are scant, and, on the other, frictional stresses may be transmitted across the contacting crack faces. The analysis of cracks under these conditions is complicated. Nevertheless, sol...

the prevalent method of irrigation in paddy fields in iran is continuous ponding, which changes to intermittent method at the time of water shortage. soil cracks are the main problem in intermittent irrigation. in this study, effects of adding rice straw on some soil physical characteristics and cracks were studied in paddy soils of the guilan province of iran. the experiment was performed as s...