Titanate nanotubes Na(2-x)H(x)Ti(3)O(7) produced by alkali hydrothermally treated ground TiO(2) aerogels are investigated as possible materials for high-temperature thermoelectric conversion by measuring their thermoelectric properties. Strikingly, the Seebeck coefficients increased sharply in the temperature range 745 to 1032 K, reaching a maximum of 302 muV/K. The electrical resistivity of th...

Combining density functional theory and the nonequilibrium Green's function method, we investigate the thermoelectric properties of thin GaAs nanowires (NWs). After identifying the most stable structures for GaAs NWs, either in wurtzite (wz) or zinc blende (zb) stacking, we present a systematic analysis on the thermoelectric properties of these NWs and their dependence on stacking type (wz or z...

In general, in thermoelectric materials the electrical conductivity σ and thermal conductivity κ are related and thus cannot be controlled independently. Previously, to maximize the thermoelectric figure of merit in state-of-the-art materials, differences in relative scaling between σ and κ as dimensions are reduced to approach the nanoscale were utilized. Here we present an approach to thermoe...

The coupled transport of heat and electrical current, or thermoelectric phenomena, can strongly influence the temperature distribution and figures of merit for phase-change memory (PCM). This paper simulates PCM devices with careful attention to thermoelectric transport and the resulting impact on programming current during the reset operation. The electrothermal simulations consider Thomson he...

Widespread application of thermoelectric devices for waste heat recovery requires low-cost high-performance materials. The currently available n-type thermoelectric materials are limited either by their low efficiencies or by being based on expensive, scarce or toxic elements. Here we report a low-cost n-type material, Te-doped Mg3Sb1.5Bi0.5, that exhibits a very high figure of merit zT ranging...

We report the fabrication and characterization of segmented element power generator modules of 16 x 16 thermoelectric elements consisting of 0.8 mm thick Bi2Te3 and 50 μm thick ErAs:(InGaAs)1-x(InAlAs)x with 0.6% ErAs by volume. Erbium Arsenide metallic nanoparticles are incorporated to create scattering centers for middle and long wavelength phonons, and to form local potential barriers for el...

Heavily boron-doped silicon layers and boron etch-stop techniques have been widely used in the fabrication of microelectromechanical systems (MEMS). This paper provides an introduction to the fabrication process of nanoscale silicon thermoelectric devices. Low-dimensional structures such as silicon nanowire (SiNW) have been considered as a promising alternative for thermoelectric applications i...

HoMnO3 and its La and Y doped compounds Ho0.67La0.33MnO3 and Ho0.67Y0.33MnO3 are investigated for their structural and thermoelectric transport properties. Small bandgaps of these compounds, as investigated by first principles calculations, make them suitable for application in thermoelectric devices. It is found that the bandgap of pure HoMnO3 increases with La and Y dopants. Thermoelectric pa...

The formulation of the classical basic equations for a thermoelectric cooler from the Thomson relations to the non-linear differential equation with Onsager’s reciprocal relations was performed to basically study the Thomson effect in conjunction with the ideal equation. The ideal equation is obtained when the Thomson coefficient is assumed to be zero. The exact solutions derived for a commerci...

The diameter-dependent thermoelectric properties of individual single-crystalline Bi nanowires grown by the on-film formation of nanowires method have been investigated. The electrical resistivity, Seebeck coefficient, and thermal conductivity were measured as functions of the nanowire diameter using an individual nanowire device. The thermoelectric figure of merit (ZT) calculated from the meas...