Objective: To assess a multiple emission peak light-emitting-diode (LED) light-curing unit (LCU) by measuring the polymerization efficiency through the degree of conversion (DC) and Knoop microhardness (KH) of a resin-based pit and fissure sealant at various light curing times and two distances compared to a single emission peak LED LCU. Method: Sixty disks of a resin-based pit and fissure seal...

Various methods of toughening the bonding between the interleaf and laminate glass fiber reinforced polymer (GFRP) have been developed due to the increasing applications in industries. A polystyrene (PS) additive modified epoxy is used to improve the diffusion and precipitation region between polysulfone (PSU) interleaf and epoxy due to its influence on the curing kinetics without changing glas...

The solvent-free in situ polymerization technique has the potential to tailor-make conformal interfaces that are essential for developing durable and safe lithium metal polymer batteries (LMPBs). Hence, much attention been given eco-friendly rapid ultraviolet (UV)-induced photopolymerization process prepare solid-state electrolytes. In this respect, an innovative method is proposed here overcom...

In this work, a novel dual-curing procedure has been developed. It is combination of first radical UV-initiated thiol-(meth)acrylate reaction, followed by second thermal thiol-epoxy step catalysed base. Since (meth)acrylates can lead to homopolymerization mechanism, the amount thiol be optimized reach cross-linked materials with Tgs above room temperature and good mechanical performance. should...

15. Supplementary Notes Project performed in cooperation with the Texas Department of Transportation and the Federal Highway Administration. 16. Abstract Curing has substantial effects on the long-term performance of Portland cement concrete (PCC) pavement. TxDOT requires two applications of curing compounds, with a maximum 180 sf/gal per each application. However, no compliance testing is cond...

AIM The aim of this study was to evaluate the heat generation of three different types of light curing units. METHODS AND MATERIALS Temperature increases were recorded from a distance of 1 mm from a thermocouple to the tip of three different types of light curing units including one quartz-tungsten halogen (QTH), one plasma arc (PAC), and one light emitting diode (LED) unit. An experimental m...

In modern research, development of monomers that reduce shrinkage of composite materials remains an ongoing quest and perennial challenge. The purpose of this study, therefore, was to analyze the shrinkage behaviour of an innovative composite material for dental restorations based on a monomer with a new chemical formulation, known as silorane. To this end, shrinkage stress development during c...

Aim The aim of this study is to evaluate and to compare the effect of different light-curing modes and different liners on cuspal deflection in premolar teeth restored with bulk filled or incrementally filled composite measured at different time intervals. Materials and Methods The study was divided into two parts (Part 1-different curing modes, Part 2-different liner) each with sixty extract...

This paper reports the results of an experimental work conducted to investigate the effect of curing conditions on the compressive strength of self-compacting geopolymer concrete prepared by using fly ash as base material and combination of sodium hydroxide and sodium silicate as alkaline activator. The experiments were conducted by varying the curing time and curing temperature in the range of...