in this study the effect of input parameters of the edm process (pulse on-time, duty cycle and tool polarity), on the material removal rate (mrr), tool wear ratio (twr) and maximum surface roughness (rmax) in the machining aisi h13 tool steel has been studied. this study shows that increasing the duty cycle in the two conditions of tool polarity, material removal rate and the maximum surface ro...

In this study the effect of Al–5Ti–1B grain refiner on the structural characteristics and wear properties of Al–12Zn–3Mg–2.5Cu alloy was investigated. The optimum amount for Ti containing grain refiners was selected as 2 wt.%. T6 heat treatment, (i.e. heating at 460 °C for 1 h before water quenching to room temperature and then aging at 120 °C for 24 h) was applied for all specimens before wear...

An experimental investigation into material transfer and wear has been performed for the case of a ferrite probe sliding at high speeds (between 25 cm/set and 1250 cm/set) and low loads (10 gm) on a steel disk, a nickel plated disk, and a polymercoated disk, the latter containing finely dispersed abrasive particles. Autoradiographic methods together with microdensitometer analysis have been app...

The capability to predict in-vivo wear of knee replacements is a valuable pre-clinical analysis tool for implant designers. Traditionally, time-consuming experimental tests provided the principal means of investigating wear. Today, computational models offer an alternative. However, the validity of these models has not been demonstrated across a range of designs and test conditions, and several...

BACKGROUND/AIMS Stannous fluoride (SnF) has been suggested as a dental erosion-preventive agent. The aim of this single-centre, randomized, double-blind, in situ study was to evaluate the effect of toothpastes with SnF in the prevention of erosive enamel wear. METHODS A combined split-mouth (extra-oral water or toothpaste brushing) and crossover (type of toothpaste) set-up was used. Twelve vo...

Polyvinyl ester green composites were synthesized with walnut shell powder (WSP) by in-situ polymerization technique. The green composites have been evaluated for mechanical properties such as tensile strength, tensile modulus and hardness. Sliding wear loss, specific wear rate and coefficient of friction were investigated by using computerized pin-on–disc machine at normal applied loads of 20,...

As the turbine industries need to manufacture turbine blades made of martensitic stainless steel AISI 420 with high toughness and wear resistance, local laser hardening has become more and more important. In this research, surface of the samples was initially hardened by high-power pulsed laser beam; then, optimum parameters of hardening were calculated and wear resistance of surface hardened s...

Nowadays steel balls wear is a major problem in mineral processing industries and forms a significant part of the grinding cost. Different factors are effective on balls wear. It is needed to find models which are capable to estimate wear rate from these factors. In this paper a back propagation neural network (BPNN) and multiple linear regression (MLR) method have been used to predict wear rat...