Abstract: The supersolidus liquid phase sintering characteristics of commercial 2024 pre-alloyed powder was studied at different sintering conditions. Pre-alloyed 2024 aluminum alloy powder was produced via air atomizing process with particle size of less than 100 µm. The solidus and liquidus temperatures of the produced alloy were determined using differential thermal analysis (DTA). The sinte...

An Aluminum based in-situ alloy reinforced with Mg2Si and Si hard particles produced by casting Al-6Si-0.5Mg alloy. The microstructure, tensile properties and fracture behavior of the alloy were investigated and the results show that the Mg2Si and Si hard particles produced by precipitation hardening have great effects. The homogenized (24hr at 500 o C) and solutionized (2hr at 540 o C) cast al...

automotive and aerospace industries are required to light materials which have high properties. this causes to reduce production cost and fuel consumption. one of these advanced materials that have been attracted at these decades is particulate metal matrix nanocomposites. these materials have a combination of ductile matrix alloy properties and ceramic reinforcement nanoparticles. powder metal...

The fabrication of a composite membrane of nanoporous gold nanowires and anodic aluminum oxide (AAO) is demonstrated by the electrodeposition of Au-Ag alloy nanowires into an AAO membrane, followed by selective etching of silver from the alloy nanowires. This composite membrane is advantageous for flow-through type catalytic reactions. The morphology evolution of the nanoporous gold nanowires a...

In this study the Taguchi method, has been applied to optimize the heat treatment parameters for the corrosion resistance of AA6061 aluminum alloy. The experimental design consisted of four parameters (aging temperature, aging time, quenching environment and NaCl concentration), each containing three levels. Tafel polarization measurements were carried out to determine the corrosion resistance ...

Rice Husk Ash (RHA) of three different particle size ranges (50 – 75 μm), (75 – 100μm) and (100 – 150μm) in 3, 6, 9 and 12 % by weight was reinforced with the aluminium alloy using stir cast route. The microstructure and mechanical properties of the fabricated composites were analyzed. The results reveal that the tensile strength, compressive strength and hardness of the aluminum alloy composit...

The electrochemical behavior of 6063 aluminum alloy in ethylene glycol-water mixture was investigated by polarization curves and AC impedance measurements (EIS).  The results obtained from polarization curves showed that corrosion rate decreased with increasing ethylene glycol concentration. EIS data showed the decrease in the interface capacitance which caused by adsorption of ethylene glycol ...

Aluminum alloys of the 6xxx series which contain excess Si or Cu are well used for the automotive applications because of the high age-hardening response. The effect of addition of small amount of Sn on the two-step aging behavior in 1.2%Mg2Si-0.5%Si in excess alloy and 1.2%Mg2Si-0.7%Cu alloy was investigated by means of hardness measurement, differential scanning calorimetry, and transmission ...

In this study, refill friction stir spot welding (RFSSW) was used to join AlSi10Mg, produced by laser powder bed fusion (LPBF), high-strength wrought AA7075-T6 alloy. The investigation showed the best mechanical properties and integrity of joint are achieved with medium heat input, where optimal balance between hook height observed. welded additive manufactured alloy shows accentuated softening...

In the paper, genetic algorithm is introduced in the study of network authority values of BP neural network, and a GA-NN algorithm is established. Based on this genetic algorithm-neural network method, a predictive model for fatigue performances of the pre-corroded aluminum alloys under a varied corrosion environmental spectrum was developed by means of training from the testing dada, and the f...