A low cost, simple solar heating system consisting of an active collector with an In-Floor Heat Distribution and Storage (IFHDS) system was developed in response to the energy crisis of the 1970s. A two-dimensional finite difference model was developed and used to simulate the performance of IFHDS system cross-sections. Simulation runs were conducted with a steady-periodic model for the tempera...

Abstract—Solar water heating is a thermodynamic process of heating water using sunlight with the help of solar water heater. Thus, solar water heater is a device used to harness solar energy. In this paper, a modified solar water heating system (MSWHS) has been proposed over flat plate collector (FPC) and Evacuated tube collector (ETC). The modifications include selection of materials other tha...

Solar energy is an environmentally sustainable energy source as it is clean and inexhaustible. Solar systems are very common and cost-effective, thus, can be used for many home applications. In this paper, a new method is presented to optimize solar systems economically, regarding to energy cost fluctuations. In spite of conventional analyses, in which the inflation is considered constant, ...

Effects of insertion of coiled wire in juxtaposition with twisted tapes on heat transfer rate and solar radiation without disturbing the flow inside the riser tubes in a solar flat plate collector is experimentally reconnoitered in this present work. The wire coil used as a turbulator is placed inside the riser tube while the twisted tape is inserted into the wire coil to create a continuous sw...

Reducing the use of conventional energy in agricultural production and food processing via using renewable is one key points to protect our environment. Solar radiation might be an excellent source for replacing traditional heat sources drying technology. This study aims analyze investigate efficiency different solar collectors apply products drying. Seven have been developed manufactured exper...

The present work evaluates the performance of solar collector using Al2O3-C2H6O2-H2O nanofluid as a working fluid through both experimental and CFD analysis. Ethylene-glycol water mixture (40:60 v/v) is used as base fluid, where α-Al2O3 nanoparticle of 20 nm average size is dispersed for the preparation of nanofluid of four different volumetric concentration (vol. conc.) of 0.05, 0.075, 0.1 and...

A TRNSYS component (Type 262) has been written to simulate a concentrating PV/Thermal collector. The component is based on a dynamic model of a concentrating PV/Thermal collector, which includes thermal capacitance effects, and detailed equations describing the temperature dependent energy flow between the collector and surroundings. The CHAPS system, a 30x concentration parabolic trough PV/The...

The performance of the Combined Heat and Power Solar (CHAPS) collectors at the Australian National University is described. Results from testing of the collector under steady state conditions at a range of input temperatures are presented. Measured results under typical operating conditions show thermal efficiency around 57% and electrical efficiency around 11%, and therefore a combined efficie...

This study examines modeling and simulation of the transient thermal behavior of a solar collector adsorber tube. The data used for model setup and validation were taken experimentally during the start-up procedure of a solar collector adsorber tube. ANN models are developed based on the nonlinear autoregressive with exogenous input NARX model and are implemented using the MATLAB® tools includi...