In a former publication from this Laboratory, results on the compressibility of various minerals and rocks were presented.' At the time when these measurements were made the importance of the physical properties of the ultrabasic rocks was not fully appreciated. Realizing that too little emphasis had been placed on these materials we have now made a number of measurements on a rock approaching ...

uniaxial compressive strength (ucs) and elastic properties of rocks play a major and vital role for the design of any engineering structure. the specimen diameter size is one of the main factors that influencing on ucs, elasticity modulus and poisson’s ratio (e and υ). here, an attempt has been made to investigate the effect of specimen diameter size on ucs, e and υ. moreover, we studied the co...

Novel laboratory equipment has been modified to allow both torsional and flexural oscillation measurements at sub-microstrain amplitudes, thereby providing seismic-frequency constraints on both the shear and compressional wave properties of cylindrical rock specimens within the linear regime. The new flexural mode capability has been tested on experimental assemblies containing fused silica con...

With the aim of simulating the behavior of saturated sand with initial static shear (i.e., sloped ground) undergoing undrained cyclic loading, which leads to liquefaction and large cyclic shear strain development, an elastoplastic constitutive model which can describe both monotonic and cyclic torsional shear behaviors of saturated sand under drained and/or undrained conditions is presented. It...

In this paper, we describe an experimental study of concrete behavior under a uniaxial tensile load by use of the thermally-compensated Coda Wave Interferometry (CWI) analysis. Under laboratory conditions, uniaxial tensile load cycles are imposed on a cylindrical concrete specimen, with continuous ultrasonic measurements being recorded within the scope of bias control protocols. A thermally-com...

An existing coupon compression fixture was modified for testing cylindrical coupon samples of pultruded material in compression. Then a new fixture was developed for testing full-size structural shapes, which presents all the advantages of the coupon fixture. Particularly, splitting of the end of the sample is prevented while reducing the stress concentration factor at the ends, yielding compre...

Parasitological examination of faeces of 26 snakes kept in Bio-Ken Snake Farm, Watamu, Kenya revealed new species of Eimeria Schneider, 1875 in Telescopus semiannulatus Smith, 1849. Oocysts of Eimeria arabukosokokensis sp. n. are cylindrical 26.8 (25-29) x 15.1 (14-16) microm with smooth, bilayered oocyst wall and a single polar granule. The broadly ellipsoidal sporocysts average 9.3 (8.5-10) x...

An investigation was carried out to understand the effects of solidification time of the cylindrical specimen on hardness, wear rate and the coefficient of friction of Aluminium alloy (LM4). The commercially available LM4 Aluminium alloy was melted in a crucible furnace under argon atmosphere. The molten metal was poured into sand moulds having dissimilar size holes. The cast rods were tested f...

We report on the microwave properties of a resonant cylindrical cavity made of bulk MgB2 superconductor, produced by the reactive liquid Mg infiltration process. The frequency response of the cavity has been measured in the range 5÷ 13 GHz. Among the various modes, the TE011, resonating at 9.79 GHz, exhibits the highest quality factor. For this mode, we have determined the temperature dependenc...

Abstract Locally adapted properties within a machine component offer opportunities to increase the performance of by using high strenght materials where they are needed. The economic production such hybrid components on other hand represents major challenge. new tailored forming process chain, which is developed collaborative research center (CRC 1153) possible solution produce components. This...