The effects of a displacive structural phase transition on sliding friction are in principle accessible to nanoscale tools such as atomic force microscopy, yet they are still surprisingly unexplored. We present model simulations demonstrating and clarifying the mechanism and potential impact of these effects. A structural order parameter inside the material will yield a contribution to stick-sl...

We have measured the surface topography and calculated the surface roughness power spectrum for an asphalt road surface. For the same surface we have measured the friction for a tire tread compound for velocities 10(-6) m s(-1) < v < 10(-3) m s(-1) at three different temperatures (at -8 °C, 20 °C and 48 °C). The friction data was shifted using the bulk viscoelasticity shift factor a(T) to form ...

The Galerkin weighted residuals method is extended solve the laminar, fully developed flow and heat transfer of Al2O3-water nanofluid inside polygonal ducts with round corners for the constant heat flux and uniform wall temperature boundary conditions. Using the method, semi-analytical, closed-form solutions are obtained for the friction coefficient and the Nusselt number in terms of the radius...

Any macroscopic deformation of a filamentous bundle is necessarily accompanied by local sliding and/or stretching of the constituent filaments. Yet the nature of the sliding friction between two aligned filaments interacting through multiple contacts remains largely unexplored. Here, by directly measuring the sliding forces between two bundled F-actin filaments, we show that these frictional fo...

–Friction stir welding is a solid state welding technology used for welding low melting point metals, such as Al, Mg and its alloys. Later welding was conducted on dissimilar metals which also produced a better defect free joint. Tool design and welding parameters contributes a major role for producing a better weld. Material flow and friction heat are the factors that the internal factor for t...

Each year, more than 25 percent of highway fatalities in the United States occur at or near horizontal curves, according to the Federal Highway Administration (FHWA). In an attempt to save lives and prevent injuries, some 30 states across the U.S. are applying high friction surfaces (HFS) to improve skid resistance at locations with a high incident of vehicle crashes such as severe horizontal c...

Single asperity friction experiments using atomic force microscopy (AFM) have been conducted on chemical vapor deposited (CVD) graphene grown on polycrystalline copper foils. Graphene substantially lowers the friction force experienced by the sliding asperity of a silicon AFM tip compared to the surrounding oxidized copper surface by a factor ranging from 1.5 to 7 over loads from the adhesive m...

1. Three men and seven women, 25-40 yr of age, were asked to use the thumb and index fingers to grasp, lift, and hold the armature of a linear motor generating a 2.0-N opposing force (simulating an object weighing approximately 200 g) for 2 s. The surface in contact with the fingers was composed of smooth or polyamide plastic etched with 1.0-mm high Braille beads separated at 2.0- or 3.0-mm int...

An outstanding challenge in protein folding is understanding the origin of "internal friction" in folding dynamics, experimentally identified from the dependence of folding rates on solvent viscosity. A possible origin suggested by simulation is the crossing of local torsion barriers. However, it was unclear why internal friction varied from protein to protein or for different folding barriers ...

In this study combined heat and mass transfer by mixed convective flow along a moving vertical flat plate with hydrodynamic slip and thermal convective boundary condition is investigated. Using similarity variables, the governing nonlinear partial differential equations are converted into a system of coupled nonlinear ordinary differential equations. The transformed equations are then solved us...