In two-phase TiAl-based alloys, the coexisting 2 and phases exhibit a thermal expansion mismatch, so that increased creep rates during thermal cycling may be expected. Creep deformation of two g-TiAl-based alloys was investigated during thermal cycles between 900 and 300 or 350 C with applied tensile stresses of 32.5 or 37.0 MPa. Measured thermal cycling creep rates were compared with isotherma...

Indentation creep tests and finite element simulations were performed on a model material to show that the constitutive equation for conventional uniaxial creep can be derived using the instrumented indentation testing technique. When the indentation pressure and the indentation creep rate are maintained at constant values of ps and _ 3⁄4inðsÞ, respectively, the contours of the equivalent stres...

With flexible leaded parts, the solder-joint failure process involves a complex interplay of creep and fatigue mechanisms. To better understand the role of creep in typical multi-hour cyclic loading conditions, a specialized non-linear finite-element creep simulation computer program has been formulated. The numerical algorithm includes the complete part-lead-solder-P WB system, accounting for ...

This paper reports (1) the latest development and application of a modified hyperbolic sine law for minimum creep strain rate and stress for both low Cr and high Cr steels, and (2) the development of a creep fracture criterion based on cavity area fraction along grain boundaries for high Cr steel. This work is part of the fundamental development of creep damage constitutive equations which were...

The spatial fluctuations of deformation are studied in the creep in Andrade's power law and the logarithmic phases, using paper samples. Measurements by the digital image correlation technique show that the relative strength of the strain rate fluctuations increases with time, in both creep regimes. In the Andrade creep phase characterized by a power-law decay of the strain rate ϵt∼t(-θ), with ...

The use of recycled construction and demolition (C&D) materials as an alternative backfill in the geosynthetic-reinforced structures, such embankments retaining walls, has been pointed out a sustainable effective means attenuating environmental impacts associated with C&D waste disposal to landfill, while also reducing natural resource depletion. Creep is important time-dependent mechanical pro...

In the present paper, a new type of surface-bonded fiber Bragg grating (FBG) dynamometry bolt is designed. It assumed that adhesive layer linear viscoelastic material and its creep mechanical behavior expressed by standard solid model. The shear strain transfer model FBG sensor established. Additionally, instantaneous quasistatic functions are obtained. validated uniaxial tensile test long-term...

1 ABSTRACT ____ An experimental study was undertaken to establish the viscoelastic behavior of IM7/K3B composite in compression at elevated temperature. Creep compliance, strain recovery and the effects of physical aging on the time dependent response was measured for uniaxial loading at several isothermal conditions below the glass transition temperature (T g). The IM7/K3B composite is a graph...

Following a successful study on the prediction of fatigue life of high-heat-load components made of Glidcop, the thermal limitation of oxygen-free copper (OFC), which is used more commonly than Glidcop, has been studied. In addition to its general mechanical properties, the low-cycle-fatigue (LCF) and creep properties of OFC were investigated in detail and compared with those of Glidcop. The br...