Integrated Composites Laboratory (ICL), Dan F Smith Department of Chemical Engineering, Lamar University, Beaumont, TX 77710, USA Department of Chemistry and Biochemistry, Lamar University, Beaumont, TX 77710, USA Department of Physics and Astronomy, Louisiana State University, Baton Rouge, LA 70803, USA Department of Chemistry and Physics and Southeastern North Carolina Regional Microanalytica...

In this paper, we report on the production of Fe cluster/FePt matrix nanocomposite permanent magnets. Monodispersed Fe clusters with sizes below 10 nm were formed by gas aggregation techniques. These Fe clusters were imbedded in an FePt matrix by alternate deposition from two sources. Specimens with a range of Fe cluster phase content from 0 to 30 vol% were produced by controlling deposition ti...

Acylated xylan-based magnetic Fe₃O₄ nanocomposite hydrogels (ACX-MNP-gels) were prepared by fabricating Fe₃O₄ nanoctahedra in situ within a hydrogel matrix which was synthesized by the copolymerization of acylated xylan (ACX) with acrylamide and N-isopropylacrylamide under ultraviolet irradiation. The size of the Fe₃O₄ fabricated within the hydrogel matrix could be adjusted through controlling ...

Hard magnetic SrFe12O19 (SrM) nanoparticles were synthesized by a facile sonochemical reaction. The magnetic nanoparticles were then added to acrylonitrile-butadiene-styrene, polystyrene, polycarbonate, and poly sulfone to make magnetic nanocomposites. The magnetic properties of the samples were also investigated using an alternating gradient force magnetometer. The strontium ferrite nanop...

Nanocomposite zinc ferrites were synthesized using glycine-nitrates by sol–gel auto-combustion technique. The influence of calcination temperatures varying from 400 to 900°C on structural and magnetic properties of spinel ZnFe2O4 powders have been investigated. The characterization measurements including X-ray diffraction (XRD), scanning electron microscopy (SEM) and vibrating sample magnetomet...

Bulk SmCo5/a-Fe nanocomposite magnets have been prepared using a Joule-heating compaction technique. Nearly fully dense bulk magnets are obtained by compacting the milled powders under a pressure of 2 GPa at temperatures above 400 C. Structural analysis shows that the grain size of both the SmCo5 and the a-Fe phases is in the range of 10 to 15 nm when the compaction temperature is lower than 50...

High intensity ultrasonic irradiation (sonication) of alkane slurries of polycrystalline YBa2Cu3O7−x leads to a significant modification of the grain morphology and, if performed with enforced oxygen flow, results in the increase of the superconducting transition temperature. Sonication with added Fe(CO)5 produces magnetic Fe2O3 nanoparticles deposited on the surface of YBa2Cu3O7−x (YBCO) granu...

a new signal amplification strategy based on simultaneous application of gold nanoparticles (aunps) and horseradish peroxidase (hrp) was employed to improve the sensitivity of an electrochemical immunoassay for detection of human igg (higg), as a model antigenic protein. this immunoassay system was fabricated on magnetic carboxyl-functionalized multi-walled carbon nanotubes (cooh-mwcnt/fe3o4 na...

The low-temperature dynamics of a magnetic nanoparticle system sg-Fe2O3—alginate nanocomposite with average particle size around 4 nmd have been studied by superconducting quantum interference device measurements. Using different temperature and field protocols, memory phenomena in the dc magnetization and magnetic relaxation have been observed at temperatures below its blocking temperature TB=...

Hydrogels sensitive to electric current are usually made of polyelectrolytes and undergo erosion, swelling, de-swelling or bending in the presence of an applied electric field. The electrical conductivity of many polymeric materials used for the fabrication of biomedical devices is not high enough to achieve an effective modulation of the functional properties, and thus, the incorporation of co...