The relative contribution of maximum muscle tetanic tension (Po) and muscle moment arm to maximum knee flexion torque was investigated in the frog hindlimb. Isometric torque was measured in frog semitendinosus muscle-bone complexes throughout the range of 0-160 degrees of flexion. Optimal joint angle (the angle at which isometric torque was maximum) was observed at 140 degrees of flexion. After...

objective: recently, a wide variation has been reported in delivery of the target torque by spring-style mechanical torque limiting devices (mtlds) but the effect of aging on their accuracy has not been independently evaluated. the purpose of this study was to determine the effect of aging on the accuracy of spring-style mtlds. methods: in this in-vitro experimental study, 15 new spring-style m...

PURPOSE To assess the maximum and end torque of a fourth-generation composite humerus model with no screw inserted or with a screw inserted in the distal (subpectoral) position or proximal (suprapectoral) position. METHODS 24 large-size, fourth-generation composite humeri were randomised to the control (n=8), proximal (n=8), or distal (n=8) group. For the latter 2 groups, an 8-mm-head interfe...

The force exerted by a muscle is a function of the activation level and the maximum (tetanic) muscle force. In "maximum" voluntary knee extensions muscle activation is lower for eccentric muscle velocities than for concentric velocities. The aim of this study was to model this "differential activation" in order to calculate the maximum voluntary knee extensor torque as a function of knee angula...

This paper presents the design of CMOS operational transconductance amplifiers (OTAs) with very small transconductance (of order of nano ampere per volt), which uses in very low frequency continuous time filters. This design uses current division technique to reduce the transconductance of OTA. This design is simulated in SPICE tool using 0.25μm technology model file.

This paper proposes a modified primary flux linkage and an improved weighting less model predictive control for linear induction motors (LIMs) to enhance the drive system in terms of speed response, wide range, efficiency, computation time. Sliding mode controller is presented this work get quick response instead use PI controller. A (MPFC) employed eliminate factor reduce Furthermore, optimum ...

The aim of this article is to draw attention to the importance of the electric current loss in the energy output of radio pulsars. We remind that even the losses attributed to the magneto-dipole radiation of a pulsar in vacuum can be written as a result of an Ampere force action of the electric currens flowing over the neutron star surface [1], [2]. It is this force that is responsible for the ...

The paper is focused on identification and measurement of the main parameters of the stacked supercapacitors (SC). The volt-ampere method was used to measure the charge/discharge characteristic, impedance spectroscopy method for measurement of the equivalent serial resistance and analysis of the dynamic parameters. The measured and calculated parameters are: equivalent serial resistance (ESR), ...