Submit Manuscript | http://medcraveonline.com Abbreviations: MB: Methylene Blue; PEC: Photo Electrochemical; Isc: Short Circuit Current; Voc: Open Circuit Voltage; XRD: X-Ray Diffraction; FE-SEM: Field Emission Scanning Electron Microscopy; AOP: Advanced Oxidation Process; CBD: Chemical Bath Deposition; EDS: Energy Dispersive X-Ray Spectroscopy; BET: Brunauer-Emmer-Teller; FWHM: Full Width At H...

Two Anderson-type heteropolyanion-supported copper phenanthroline redox couples have been successfully introduced into dye-sensitized solar cells, which can significantly increase the short-circuit photocurrent, open-circuit voltage and the conversion efficiency by 2.2 times, 26.8% and 3.93 times respectively, compared to the pristine copper phenanthroline redox couple.

In this paper, a new circuit scheme is proposed to reduce the power consumption of dynamic circuits. In the proposed circuit, an NMOS keeper transistor is used to maintain the voltage level in the output node against charge sharing, leakage current and noise sources. Using the proposed keeper scheme, the voltage swing on the dynamic node is lowered to reduce the power consumption of wide fan-in...

Voltage boosting from CMOS photovoltaic device (PV) is achieved by implementing multiple PV units on single CMOS chip and are series connected by an external integrated passive device. Localized substrate removal process is developed to electrically isolate the PV units. Four-cell cascaded CMOS PV module provides an open-circuit voltage of 2.05 V while maintaining its superior PV performance.

A DC-DC step-up micro power converter for solar energy harvesting applications is presented. The circuit is based on a switchedcapacitor voltage tripler architecture with MOSFET capacitors, which results in an area approximately eight times smaller than using MiM capacitors for the 0.13μm CMOS technology. In order to compensate for the loss of efficiency, due to the larger parasitic capacitance...

Two different techniques for the electronic surface passivation of silicon solar cells, the plasma-enhanced chemical vapour deposition of silicon nitride (SiN) and the fabrication of thin thermal silicon oxide/plasma SiN stack structures, are investigated. It is demonstrated that, despite their low thermal budget, both techniques are capable of giving an outstanding surface passivation quality ...

in this study, the four cr-mn-(ni-free) austenitic steels were fabricated by vacuum induction furnace. then plates with 10 mm thickness were fabricated by hot-rolling. corrosion behaviour of the four cr-mn steels in 0.1 m h2so4 solution was investigated using by open-circuit potential, potentiodynamic polarization, and electrochemical impedance spectroscopy (eis). the results indicated that the...

ABSTRACT: In the power generation sector, Natural Resources like Solar, Wind, Tidal, Geothermal, Hydro etc have always played a very important role. Out of these solar PV (photo voltaic) is most popular due to its significant advantages. However the solar radiation never remains constant. It keeps on varying throughout the day. In this paper, single 60 W solar PV panel along with boost converte...

This paper presents a fast coordinated control scheme of the rotor side converter (RSC), the Direct Current (DC) chopper and the grid side converter (GSC) of doubly fed induction generator (DFIG) wind turbine generators (WTGs) to improve the low voltage ride through (LVRT) and high voltage ride through (HVRT) capability of the DFIG WTGs. The characteristics of DFIG WTGs under voltage sags and s...