This paper describes features in the structure of a laminar vortex ring ejected vertically from an elevated pipe into a uniform horizontal cross flow. Measurements are obtained by particleimage velocimetry (PIV) and flow-visualisation images are obtained by planar-laser-induced fluorescence (PLIF). Cross flow produces a shear layer over the open end of the elevated pipe. As a vortex ring is eje...

We present a numerical technique for treating unsteady, low Mach number reacting flow. For fast chemistry nonpremixed combustion, the reaction effects are generated using a conserved scalar, the mixture fraction. Such an approach yields species concentration information via post-processing rather than through the integration of species equations. Limits on the range of the conserved scalar are ...

this paper presents the effect of high viscosity oil and two-phase foamy-oil flow on the performance of a single stage centrifugal pump. as a part of this, the applicability of a pipe viscometer to determine the foamy oil viscosity is investigated. unlike previous studies, a sealed fluid tank is used in a closed flow loop to allow conditioning the two-phase mixture to create foamy-oil. furtherm...

the monolithic catalytic converter is still the main pollution control device for modern vehicles in order to reach the ever-increasing legislative demands for low emission standards. the catalytic converters require a large expansion from the exhaust pipe to the front face of the monolith. unfortunately, packaging constraints often do not permit the use of long diffusers. hence, flow separatio...

In this study, turbulent compressible gas flow in a rectangular micro-channel is numerically investigated. The gas flow assumed to be in the subsonic regime up to Mach number about 0.7. Five low and high Reynolds number RANS turbulence models are used for modeling the turbulent flow. Two types of mesh are generated depending on the employed turbulence model. The computations are performed for R...

multiphase flows are commonly encountered in oil and gas industries. the transport of multiphase flow causes the formation of slug, the increase of pressure drop and the possibility of phase changes therefore, a set of simulation runs was performed to predict flow regimes in a horizontal pipeline, and the results were compared with the baker chart. the effects of small downward inclinations of ...

Flow in a circular pipe fitted with segmental baffles may be treated as a shellwithout-tube system. Its pressure drop has been calculated by adapting the Kern correlation [1] for pressure drop in the shell side of shell-and-tube heat exchangers. The Kern correlation is essentially based on the Hagen – Poiseuille equation for laminar flow, but flow visualization results presented here show that ...

The purpose of the air distribution system in a fluidised bed combustor is to provide a reasonably uniform spread of combustion air over the entire horizontal cross-sectional area of the bed. One of the simplest, and hence cheapest, forms of air distributor is the sparge pipe design, in which an array of horizontal pipes is fitted at the base of the bed. Combustion air is then supplied to one e...

Industries which pump sludges are under continuous pressure to decrease water content, and increase concentration. Environmentally superior disposal techniques are demanding that such sludges have high mechanical strength properties. This results in a sludge with an increasing viscous character. At high concentration, the viscous forces – which are usually highly non-Newtonian and yield stress ...