The surface energy present in a small drop of liquid is used to pump the liquid through a microchannel. The flow rate is determined by the volume of the drop present on the pumping port of the microchannel. A flow rate of 1.25 microL s(-1) is demonstrated using 0.5 microL drops of water. Two other fluid manipulations are demonstrated using the passive pumping method: pumping liquid to a higher ...

in present paper, dynamic behavior and control of a fluidized bed reactor for polyethylene production has been considered. a double active sites model for ziegler-natta catalysts is used for simulation of polymerization reaction. hydrodynamic behavior of the bed is modeled using a two phase model including bubble and emulsion phases in which bubble phase has plug flow pattern with differentiall...

in this study, a laboratory scale continuous plug flow fluidized bed dryer was designed and constructed. a backward-curved centrifugal fan with a 4 kw electromotor was selected based on the maximum pressure drop in the minimum fluidization state and the ability to produce the velocity required for fluidization of the most granular agricultural materials. the fluidization chamber was a rectangul...

Although computational fluid dynamics is well suited for modeling the dynamics of zeronet mass-flux (ZNMF) actuators, the computational costs associated with large-scale flow control simulations necessitate the use of simple models for these devices. A new model based on only the slot of ZNMF jets in grazing flows is proposed. A study of the dimensionless parameters governing the ZNMF jet in gr...

This paper describes the heat and mass transfer in a square microchannel that is heated from one side. This microchannel represents a reaction channel in a microreactor that is used to study the kinetics of the catalytic partial oxidation of methane. The microchannel is contained in a silicon wafer and is covered by a thin silicon sheet. At the top side of this sheet, heating elements are prese...

We study the dynamical behavior of a large bubble embedded in the plug flow of an ordered two-dimensional foam. At a critical velocity, the foam structure becomes instable and the large bubble migrates through the foam faster than the mean flow. This size segregation is due to viscous effects and happens only for flow velocities larger than a given threshold. We present analytical and numerical...

The experimental conditions of the sample delivery inside the reagent-release capillary-based capillary-assembled microchip (RRC-based CAs-CHIP) were optimized and the reagent release procedure in the RRC is discussed. Recently, our group introduced the basic concept of the "drop-and-sip" fluid handling technique (Anal. Chem., 2007, 79, 908). A microliter volume of sample solution is dropped on...