Rossby wave propagation theory predicts that Rossby waves in a tropical easterly flow cannot escape from the Tropics to the extratropics. Here the authors show that a southerly flow component in the basic state (a southerly conveyor) may transfer a Rossby wave source northward; thus, a forcing embedded in the deep tropical easterlies may excite a Rossby wave response in the extratropical wester...

The current-conveyor has precise unity gain between Z and X (Fig. 1), rather than the high ill-defined open-loop gain of the voltage op-amp, therefore in amplifier applications the current-conveyor is generally used without any overall negative feedback. The advantage of this approach is that the traditional closed-loop gainbandwidth conflict of negative feedback voltage op-amp circuits is avoi...

This paper is concerned with the dynamic range of continuous time CMOS current mode circuits. As a representative current mode device a class AB current conveyor is examined. First, the voltage input range of the high impedance Y input is investigated. Next, the current input range of the low impedance X input is investigated. It is compared to the thermal noise in the X to Z signal path in ord...

In this contribution, three nonlinear control strategies are presented for a two-degree-offreedom parallel robot that is actuated by two pairs of pneumatic muscle actuators as depicted in Fig. 1. Pneumatic muscles are innovative tensile actuators consisting of a fibrereinforced vulcanised rubber hose with appropriate connectors at both ends. The working principle is based on a rhombical fibre s...

An experimental study concerning particle behaviors in a horizontal dilute swirling flow pneumatic conveying was performed. Measurements of particle velocities and concentration profiles have been carried out using the photographic image technique. From the experimental results, it is found that mean particle velocity of swirling flow pneumatic conveying is lower than that of conventional pneum...

One strategy for actuating soft machines (e.g., tentacles, grippers, and simple walkers) uses pneumatic inflation of networks of small channels in an elastomeric material. Although the management of a few pneumatic inputs and valves to control pressurized gas is straightforward, the fabrication and operation of manifolds containing many (>50) independent valves is an unsolved problem. Complex p...

The objective of this paper is to present the methods of development and study of control law of rodless pneumatic actuator with fuzzy regulator in order to improve the accuracy of the pneumatic drive carriage positioning. The basis for improving the accuracy of positioning of the pneumatic actuator is the Intelligent Control System.

This paper reports on existing and novel transducers for improved quantitative investigations of the levels of applied pressures and pressure gradients produced on human limbs by non-pneumatic tourniquet straps, and by non-pneumatic elastic bandages and elastic rolls when used as tourniquets, for comparison to benchmark data for pneumatic tourniquet cuffs commonly used in surgery at present.

The effect on Atlantic overturning of changes in zonal and meridional atmospheric moisture transports is investigated. Zonal transports are considered in terms of net moisture export from the Atlantic sector. Meridional transports are related to vigour of the global hydrological cycle. The equilibrium thermohaline circulation (THC) simulated with an efficient climate model is strongly dependent...

An equivalence between a class of (current conveyor) CC II+ and CC IIcircuits is established. CC IIequivalent circuit uses one extra element. However, under certain condition, the extra element can be eliminated. As an illustration of the application of this equivalence, minimal first and second order all-pass filters are derived. In certain cases, it is possible to compensate the effect of the...