This paper proposes a control method that can balance the input current of the three phase, three wire, Boost rectifier under unbalanced input voltage condition. The control objective is to operate the rectifier in the high power factor mode under normal operating condition but to give ovemdmg priority to the current balance function in case of unbalance in the input voltages. The inner loop im...

1. The kinetics of inactivation of delayed rectifier K+ current in murine colonic myocytes differed in amphotericin-permeabilized patch and conventional patch clamp. The difference was accounted for by Ca2+ buffering. 2. Calcium-calmodulin-dependent protein kinase II (CaMKII) inhibitors increased the rate of inactivation and slowed recovery from inactivation of the outward current. This was see...

Inwardly rectifying K+ (IRK) channels are critical for shaping cell excitability. Whole-cell patch-clamp and single-cell RT-PCR techniques were used to characterize the inwardly rectifying K+ currents found in projection neurons of the rat nucleus accumbens. Inwardly rectifying currents were highly selective for K+ and blocked by low millimolar concentrations of Cs+ or Ba2+. In a subset of neur...

A combination of rectifier and DC – DC chopper is useful in feeding DC loads where the DC input to the loads needs to be stepped up or down. Both rectifier and chopper are based on power electronic switches which inject harmonics in the system. This harmonics is an undesirable effect which should be mitigated effectively. For this, passive harmonic filters are used. Passive harmonic filters are...

Two stochastic methods for locating global minimum and optimal design parameters of a rectifier power transformer, by Genetic Algorithm (GA) and Simulated Annealing (SA) are presented. A closed form expression for actual phase current waveform of the rectifier transformer is derived and a comparison is made with the approximate waveform normally considered for fixing the transformer rating. The...

We demonstrate an integrated organic double half-wave rectifier for use in organic radio frequency identification RFID tags. This rectifier comprises two organic Schottky diodes, each followed by a capacitor, integrated on the same foil. This rectifier delivers approximately twice the dc voltage of single half-wave rectifiers. Its offset voltage is merely 2 V. It is able to generate voltages of...

A closed-loop controlled wireless power transmission circuit block for implantable biomedical applications is described in this paper. The circuit consists of one front-end rectifier, power management sub-block including bandgap reference and low drop-out regulators (LDOs) as well as transmission power detection / feedback circuits. Simulation result shows that the front-end rectifier achieves ...

Single-phase 3-level neutral point clamped cascaded rectifier (3LNPC-CR) has been successfully made its way into traction drive system as a high-voltage traction converter. In this passage, the control issue of the 3LNPC-CR is considered. A transient current control strategy, combined with proportional integral (PI) controllers, is adopted to achieve unity power factor, satisfactory sinusoidal ...

This paper describes an investigation into the development of a new generation of threephase rectifier, used to power telecommunications equipment. Traditionally, the topology used is a single-phase two-stage design, with a boost converter at the input to the first stage and an isolated dcdc converter making up the second stage. The boost converter provides power factor correction which is nece...

This paper presents a new type diode connected MOS transistor to improve CMOS conventional rectifier's performance in RF energy harvester systems for wireless sensor networks in which the circuits are designed in 0.18  μm TSMC CMOS technology. The proposed diode connected MOS transistor uses a new bulk connection which leads to reduction in the threshold voltage and leakage current; therefore, ...