Effective manipulation of cavity resonant modes is crucial for emission control in laser physics and applications. Using the concept of parity-time symmetry to exploit the interplay between gain and loss (i.e., light amplification and absorption), we demonstrate a parity-time symmetry-breaking laser with resonant modes that can be controlled at will. In contrast to conventional ring cavity lase...

The FSQ-series FPSTM (Fairchild Power Switch) is an integrated Pulse Width Modulation (PWM) controller and Sense FET specifically designed for quasi-resonant off-line Switch Mode Power Supplies (SMPS) with minimal external components. Figure 1 shows the internal block diagram of the FSQ-series. Compared with discrete MOSFET and PWM controller solution, it can reduce total cost, component count,...

We derived an analytical expression for a resonant-mode based bi-layered cantilever with distributed mass load. The behavior of mode of vibration, nodal position, frequency shift, as well as sensitivity under different mass load distributions was theoretically studied. The theoretical results suggested that asymmetric mass load distribution leads to the shift of nodes as well as the sensitive r...

In a multimodal volume coil, only one mode can generate homogeneous Radiofrequency (RF) field for Magnetic Resonance Imaging. The existence of other modes may increase the volume coil design difficulties and potentially decreases coil performance. In this study, we introduce common-mode resonator technique to high and ultrahigh field volume coil designs to reduce the resonant mode while maintai...

The class Φ2 inverter is a new switched mode type of resonant inverter. This inverter is applicable for very high frequency application. In this paper, it proposes class Φ2 inverter reduced the voltage stress, and improve the dynamic response. The class E resonant inverter is not suitable for high frequency application, because it produce high voltage stress across the switch. The suitable ball...

A new approach to single-qubit operations using exchange interactions of single electrons in gate-defined quantum dots has recently been demonstrated: the resonant exchange qubit. We show that two-qubit operations, specifically the controlled phase gate, can be performed between resonant exchange qubits very straightforwardly, using a single exchange pulse. This is in marked contrast to the bes...

First direct measurements of nonambipolar magnetic fluctuation-induced charge transport in the interior of a high-temperature plasma are reported. Global resistive tearing modes drive the charge transport which is measured in the vicinity of the resonant surface for the dominant core resonant mode. Finite charge transport has two important consequences. First, it generates a potential well alon...

-In-situ studies on the performance of an ultrasonic wire-bonding transducer (about 60 kHz) are presented and discussed in this paper in order to optimize the bonding process. The resonant frequencies and vibration mode shapes of the transducer were computed using finite element method (FEM) and were compared with the experimental resonant frequencies and displacement distributions. Good agreem...

Methods are developed for study of isotropic cubes via resonant ultrasound spectroscopy. To that end, mode structure maps are determined for freely vibrating isotropic cubes via finite element method over the full range of Poisson's ratio ν (-1 to +0.5). The fundamental torsional mode has the lowest frequency provided ν is between about -0.31 and +0.5. Experimental measurements for the mode str...

Step-by-step procedures for designing a third order bandpass filter and a sixth order bandpass filter using a triple-mode resonator are described in this paper. The triple-mode resonator is a square open-loop resonator with an open circuited stepped-impedance stub and a grounding via located at the symmetrical plane of the resonator. The equations for approximating the resonant frequencies of t...