By integrating the lattice Boltzmann model for hydrodynamics, the lattice spring model for micromechanics of elastic solids, and the Bell model for bond formation and rupture, we examine the fluid driven motion of elastic microcapsules on compliant surfaces. The capsules, modeled as threedimensional fluid-filled elastic shells, represent polymeric microcapsules or biological cells. We observed ...

An Al/Stainless Steel/Al lamellar composite was produced by roll bonding of the starting sheets at 400 °C. Afterward, the roll bonded sheet was cut in half and the accumulative roll bonding (ARB) process at room temperature was applied seven times. As a result, the central steel layer fractured and distributed in the Al matrix among different layers introduced by the repetition of roll bonding ...

In order to automate the scooping task, it is desirable that the resistive force acting on the bucket be obtained before the scooping is performed. The objective of this study is to derive theoretically the resistive forces acting on the bucket during scooping of piled rock fragments. First, the changes in the shape of the rock pile due to the penetration of it by the bucket are modeled. Based ...

Analytical models for channel potential, threshold voltage, and subthreshold swing of the short-channel fin-shaped field-effect transistor (FinFET) are obtained. The analytical model results are verified against simulations and good agreements are observed. Analytical expressions for subthreshold swing, drain induced barrier lowering effect, and threshold voltage roll-off characteristics are pr...

In this paper, an analytical method based on Modified Slab Method of analysis is presented to study the asymmetrical rolling process due to difference in work rolls radii, rolls speeds and interface frictions. The shear force imposed on material along the contact region is considered to be a function of the frictional factor and the roll gap geometry. Elastic-plastic with linear work hardening ...

The ability of zeotropic mixtures with a temperature glide to operate in liquid recirculation systems is investigated in this paper, and the preliminary results of an experimental comparison between the performance of R134a and of zeotropic mixture R32/Rl34a, (25/75 by mass) are presented. The perfonnance of Rl34a operating in dry expansion mode are also presented as baseline data. INTRODUCTION...

Cellulose nanofibril (CNF) suspensions are not easily coatable because of their excessively high viscosity and yield stress, even at low solids concentrations. In addition, CNF suspensions vary widely in their properties depending on the production process used, which can affect their processability. This work reports roll-to-roll coating of three different types of CNF suspensions with a slot-...

Small amounts of useful power may be generated in polar or subpolar regions during the winter period by placing a heat engine between a large body of water (near PC), acting as a heat source, and the atmosphere (near -25OC), acting as a heat sink. The scheme consists of a fuelless modular system operating on the Carnot cycle. Power is extracted by a reciprocating vapour engine drawing saturated...

This paper presents the experimental as well as the simulated performance studies on the transcritical CO2 heat pumps for simultaneous water cooling and heating; effects of water mass flow rates and water inlet temperatures of both evaporator and gas cooler on the cooling and heating capacities, system COP and water outlets temperatures are investigated. Study shows that both the water mass flo...