Tribological characteristics of fine-grained WC–8 wt%Ni with different surface finishing conditions corresponding to sequential wire electrical discharge machining (wire-EDM) or grinding were investigated by performing dry reciprocating sliding experiments on TE77 pin-on-plate equipment with WC–6 wt%Co as mating material. Surface finishes and wear surfaces were characterized using surface topog...

This work presents a new criterion for the tool wear evaluation from cutting tool vibration. The vibratory signatures produced during a dry turning process were acquired using a three-axis accelerometer mounted on cutting tool. Then, the mean power analysis was estimated to extract an indicator parameter able to describe the wear of the cutting tool along its lifespan. Finally, a criterion base...

In dry sliding conditions, polytetrafluoroethylene (PTFE) composites can form thin, uniform, and protective transfer films on hard, metallic counterfaces that may play a significant role in friction and wear control. Qualitative characterizations of transfer film morphology, composition, and adhesion to the counterface suggest they are all good predictors of friction and, particularly, wear per...

Carbon-fiber-reinforced silicon carbide (C/C-SiC) composite is widely used as a friction material owing to its good performance, even though it is more expensive than metallic materials. The light C/C-SiC composite is an ideal candidate for weight reduction of frictional parts. In this study, the friction and wear behavior of C/C-SiC composite was assessed using a ball-on-disk friction tester u...

In the present investigation, an attempt is made to study the effect of addition of grain refinement on Al-Si alloy, when it is subjected to the combined grain refiner addition (Al-5T-1B) and subjected to mechanical vibration and heat treatment. The material is tested for hardness property and dry sliding wear properties. The results of the present investigation indicate that there is a conside...

The water characteristics of acrylic denture teeth were investigated under single- and double-pass sliding. The response of acrylic teeth to sliding was that of a relatively ductile material. The wear characteristics were affected similarly by environments of water and saliva. The "enamel" surfaces showed more resistance to penetration and were less susceptible to surface damage than the "denti...

A slider-slab sliding model for hard-to-soft and soft-to-soft sliding systems with abrasive and non-abrasive wear conditions is used to investigate atomic-scale friction. The molecular dynamics simulation uses the Morse potential to calculate interatomic forces between atoms. Separation distance between the slider and the slab is changed to simulate repulsive and attractive interactive force fi...

The effect of the microstructure on the wear modes in structural ceramic materials was studied in two SIC and three A120s materials. In each class of materials, it was observed that the predominant damage mode is determined by the microstructure of the material. The materials with weak grain boundaries were found to wear primarily by grain pluckout and so showed more wear than did (the one, cr-...

Intermetallic compounds are increasingly being expected to be utilized in tribological environments, but to date their implementation is hindered by insufficient ductility at low and medium temperatures. This paper presents a novel multiphase intermetallic alloy with the chemical composition of Mo-40Ni-13Si (at %). Microstructure characterization reveals that a certain amount of ductile Mo phas...

Finding a wear law that is valid over a wide range of conditions and materials would have enormous practical value. The authors have previously iscovered a simple relationship describing the evolution of the abrasive wear rate of steel sliding against boron carbide-coated coupons, and have eveloped a model accounting for its kinetics. The authors show here that this wear equation accurately des...