Parameter Optimization of Robust Low Bit Rate Video Coders Sangyoun Lee and Vijay K. Madisetti Digital Signal Processing Laboratory School of Electrical and Computer Engineering Georgia Institute of Technology Atlanta, GA 30332-0250, U.S.A Abstract|Most standards provide a generalized syntax and semantics framework for video coders, leaving the selection and optimization of the right parameter ...

This research combined the Taguchi method and artificial intelligence methods, used them as the prediction tool in wire bond designing parameters for an Ultra-Thin CSP package, and then constructed a set of the optimal parameter analysis flow and steps. This paper employed desirability function to integrate two quality characteristics (loop height and wire pull strength) into a single quality i...

This paper outlines the fractional factorial approach of D.O.E. techniques (Taguchi & Response Surface Methodology) are applied to optimize turning process parameter in order to obtain better surface finish. The turning parameters evaluated are cutting speed, feed, and depth of cut. An orthogonal array, signal-to-noise (S/N) ratio, and Pareto analysis of variance (ANOVA) are employed to analyze...

Despite the industrial popularity of nylon 6 composites, their wear performance portrays a substantial knowledge gap on parametric importance. Consequently, this study optimizes and prioritizes parameters 6/boron nitride composites using Taguchi-Pareto Taguchi-ABC methods based 80-20 Pareto rule ABC analysis, signal-to-noise ratios. From literature information, principal considered are %wt rein...

The present study investigates the effect of turning process parameters on surface roughness and metal removal rate (MRR) AISI 1040 steel. Twenty-seven ( L27) runs based an orthogonal array Taguchi techniques were performed grey relational analysis method was later applied to determine a most favourable setting. Apart from this, variance (ANOVA) conducted statically identify significant paramet...

ABSTARCT This paper envisages the optimal setting of process parameters which influences the surface roughness during the machining operation of En 41B alloy steel with cermet tool. Experiments have been carried out by using Taguchi design. The surface roughness is considered as quality characteristic while the process parameters considered are speed, feed and depth of cut. The results of the m...

The present study applied extended Taguchi method through a case study in straight turning of mild steel bar using HSS tool for the optimization of process param. The study aimed at evaluating the best process environment which could simultaneously satisfy requirements of both quality as well as productivity with special emphasis on reduction of cutting tool flank wear, because reduction in fla...

This paper involves the multi-objective optimization of process parameters of AlSi10Mg/9 wt% alumina/3 wt% graphite in Electrical Discharge Machining for obtaining minimum surface roughness, minimum tool wear rate and maximum material removal rate. The important machining parameters were selected as peak current, flushing pressure and pulse-on time. Experiments were conducted by selecting diffe...