A general method for brazing ceramics to metals using a compliant metallic foam as a buffer layer has been developed. Using stainless steel foams, bonds between alumina and 316 stainless steel with shear strengths up to 33 MPa have been achieved. The resultant ductility enhances the resistance of the joint to thermal cycling; AlN-Inconel 600 bonds exhibited good thermal shock resistance. Alumin...

We have measured the thermal resistance of a 152-nm-diameter carbon nanofiber before and after a platinum layer was deposited on the contacts between the nanofiber and the measurement device. The contact resistance was reduced by the platinum coating for about 9–13% of the total thermal resistance of the nanofiber sample before the platinum coating. At a temperature of 300 K, the axial thermal ...

: We present a fabrication process of low-cost superlattices and simulations related with the heat dissipation on them. The influence of the interfacial roughness on the thermal conductivity of semiconductor/semiconductor superlattices was studied by equilibrium and non-equilibrium molecular dynamics and on the Kapitza resistance of superlattice's interfaces by equilibrium molecular dynamics. T...

Unique specifications of metal foams such as relatively low cost, ultra-low density, high surface-area-to-volume ratio, and most importantly, the ability to mix the passing fluid provide them a great potential for a variety of thermal-fluidics

From macrostructure of EDLC (Electrochemical double layer capacitor) it is possible to figure out, that for the heat conduction the volumetric properties of EDLC acts as anisotropic surroundings. This structure is in axial and radial direction of EDLC coil geometrically and physically different. Heat transfer through this structure is therefore different in axial direction against heat transfer...

Thermal diffusion measurements on polymethylmethacrylate-coated Si substrates using heated atomic force microscopy tips were performed to determine the contact resistance between an organic thin film and Si. The measurement methodology presented demonstrates how the thermal contrast signal obtained during a force-displacement ramp is used to quantify the resistance to heat transfer through an i...

In this paper we describe a novel long-term microhotplate temperature sensor calibration technique suitable for Built-In Self Test (BIST). The microhotplate thermal resistance (thermal efficiency) and the thermal voltage from an integrated platinum-rhodium thermocouple were calibrated against a freshly calibrated four-wire polysilicon microhotplate-heater temperature sensor (heater) that is not...

Sputtered reactive multilayers applied as a heat source in electronic joining processes are an emerging technology. Their use promises low-stress assembly of components while improving thermal contact and reducing thermal resistance. Nanostructured surface modifications can significantly enhance adhesion and reliability of joints between different materials. This work examines reactive multilay...