The paper is concerned with the study of magneto-thermoelastic interactions in three dimensional thermoelastic medium under the purview of three-phase-lag model of generalized thermoelasticity. The medium under consideration is assumed to be homogeneous orthotropic medium. The fundamental equations of the three-dimensional problem of generalized thermoelasticity are obtained as a vector-matrix ...

An analysis is given of thermoelastic noise ~thermal noise due to thermoelastic dissipation! in finite sized test masses of laser interferometer gravitational-wave detectors. Finite-size effects increase the thermoelastic noise by a modest amount; for example, for the sapphire test masses tentatively planned for LIGO-II and plausible beam-spot radii, the increase is &10 percent. As a side issue...

The mechanisms of photomechanical spallation are investigated in a large-scale MD simulation of laser interaction with a molecular target performed in an irradiation regime of inertial stress confinement. The relaxation of laser-induced thermoelastic stresses is found to be responsible for the nucleation, growth, and coalescence of voids in a broad sub-surface region of the irradiated target. T...

The present work describes the experimental mechanical characterisation of a natural flax fibre reinforced epoxy polymer composite. A commercial plain woven quasi-unidirectional flax fabric with spun-twisted yarns is employed in particular, as well as unidirectional composite panels manufactured with three techniques: hand-lay-up, vacuum bagging and resin infusion. The stiffness and strength be...

In all laser treatments at the fundus of the eye the temperature increase is unknown. In order to optimize the treatment modalities, a noninvasive online temperature determination is preferable. Method: Applying laser pulses to the fundus, thermoelastic stress waves are emitted based on the thermal expansion of the heated tissue, mainly the retinal pigment epithelium (RPE). The amplitude of the...

The present article deals with the two parts: (i)The propagation of plane waves in a microstretch thermoelastic diffusion solid of infinite extent. (ii)The reflection and transmission of plane waves at a plane interface between inviscid fluid half-space and micropolar thermoelastic diffusion solid half-space.It is found that for two-dimensional model, there exist four coupled longitudinal waves...

The relation between shortening heat and sarcomere length was studied using fiber bundles from frog semitendinosus muscles as well as using whole muscles. The initial sarcomere length was varied between 2.0 and 3.66 micron. Shortening heat was estimated as the excess heat produced after a rapid isovelocity release in a 3 sec tetanus at 0 degrees C. The isometric control heat was measured in the...

The importance of thermoelastic damping as a fundamental dissipation mechanism for small-scale mechanical resonators is evaluated in light of recent efforts to design high-Q micrometerand nanometer-scale electromechanical systems. The equations of linear thermoelasticity are used to give a simple derivation for thermoelastic damping of small flexural vibrations in thin beams. It is shown that Z...

When evaluating the safety of steel structures, welding residual stress is used as secondary load and if there any restraint, yield base material for load, regardless size restraint. Of late, members increasing with increase in use high-strength steels, proportion total during evaluation structures increasing. Therefore, it necessary to investigate effect restraint on stress, determine reasonab...

If two thermally conducting bodies are in sliding contact, the frictional heat generated at the interfaces causes thermoelastic distortion which profoundly influences the extent of the contact area and the distribution of contact stress [1]. This phenomenon now known as thermoelastic instability has been observed experimentally in a wide range of practical sliding systems [2, 3]. Several theore...