This paper presents the comparative analysis of improved quality three phase AC/DC boost converters, using SIMULINK. Comparison of three phase controlled single switch and six switch AC/DC boost converters have been done to identify the boost converter with low cost/small size/high efficiency for three phase system. Three phase AC/DC boost converters with improved quality in terms of power fact...

This paper compares the performance of diode clamped three level inverter based STATCOM with sinusoidal and space vector PWM techniques. Space Vector Pulse Width Modulation (SVPWM) technique is the most advantageous technique than the conventional sinusoidal PWM technique for a multilevel inverter. The space vector pulse width modulation technique is an advanced, computation-intensive PWM metho...

This paper presents a performance of the canonical switching cell (CSC) converter fed brushless DC (BLDC) motor drive for power quality (PQ) improvement. The use of CSC not only controlled the DC link voltage but also make the inverter to operate at low frequency so that switching losses are minimized. Moreover the use of front end CSC improves the power factor at AC mains. The system needs onl...

The voltage source inverter (VSI) and current voltage source inverter (CSI) are widely used in industrial application. But the traditional VSIs and CSIs have one common problem: can’t boost or buck the voltage come from battery, which make them impossible to be used alone in Hybrid Electric Vehicle (HEV/EV) motor drive application, other issue is the traditional inverter need to add the dead-ba...

A novel lOOMHz CMOS G,-C seventh-order 0.05" equiripple linear phase low-pass multiple loop feedback (MLF) filter based on the Leapfrog (LF) topology is presented. The filter is implemented using a fully-differential linear, high performance operational transconductance amplifier (OTA) based on crosscoupled pairs. PSpice simulations in a standard TSMC 0.25pm CMOS process and with a single 5V po...

At present scenario, renewable energy sources are needed to meet the energy demand. They also mitigate environment pollution problems. The shortage of electrical energy demand can be meeting with renewable energy resources. A wind turbine (WT) and photovoltaic (PV) solar panels are primary energy sources. Grid connected renewable energy source like wind energy and solar energy are used to conne...

This work investigates the ways that Automatic Gain Control (AGC) operation can be modified to minimise the Signal-to-Noise Ratio (SNR) losses in the presence of a Continuous-Wave (CW) interferer for Global Navigation Satellite System (GNSS) receivers. It was found that the recommendations based on analysis of a probabilistic model of a Direct Sequence Pseudorandom Noise (DSPN) receiver reporte...

Multilevel converters are a very interesting alternative for medium and high power drives. Of these topologies the Multicell group is popularly growing due to its advantages such as modularity and scalability. This paper proposes a new topology of cascaded H bridge Multicell 15 level Inverter which is the mixed form of flying capacitor and cascaded group. This inverter is based on the cascaded ...

This paper proposes and discusses a novel AC/DC converter suitable for small-scaled wind power generation system applications. By introducing flyback cells into the three-phase single-switch Boost circuit, the proposed converter is designed as single-stage and has both rectification and high step-up power conversion functions. It is able to obtain high voltage gain at low input voltage level, a...

A highly linear fully differential CMOS transconductor architecture based on flipped voltage follower (FVF) is proposed. The linearity of the proposed architecture is improved by mobility reduction compensation technique. The simulated total harmonic distortion (THD) of the proposed transconductor with 0.4Vpp differential input is improved from 42 dB to 55 dB while operating from 1.0 V supply. ...