This paper presents the performance of the extended Kalman filter (EKF) for speed sensorless indirect field oriented control (IFOC) of a squirrel cage induction motor (IM) supplied by a pulse width modulated (PWM) voltage-source inverter. The rotor speed of the induction motor is estimated, according to this method, using the direct measurements of the stator voltages and currents without the s...

This paper deals with the analysis, design and control of a small power standalone solar photovoltaic (SPV) generating system. A PV array of 33V-43.2V is taken as an input and its output voltage is achieved as 360V dc using a flyback converter. The battery is charged at this voltage and using a single-phase voltage source inverter (VSI) it is converted into a single phase ac of 220Vac, 50 Hz. A...

This project presents a three-level diode-clamped inverter feeding an asynchronous motor drive with direct torque control (DTC). The control method is based on DTC operating principles. The stator voltage vector reference is computed from the stator flux and torque errors imposed by the flux and torque controllers. This voltage reference is then generated using a diode-clamped inverter, where e...

A new control structure for sensorless induction machine dedicated to electrical drives using a three-level voltage source inverter VSI-NPC is completely analysed. The amplitude and the rotating velocity of the flux vector could be controlled freely. Both fast torque and optimal switching logic could be achieved; the selection is based on the value of the stator flux and the torque. A novel DTC...

The objective is to develop a fault diagnose scheme for MOSFET’s open switch faults for PWM voltage source inverter (PWM-VSI) motor drives. Here system monitors line to line voltage as well as switching signals nevertheless the triggering time of MOSFET, under both healthy and faulty conditions. So the measurement of line to line voltage is taken which gives the information about switching stat...

This paper proposes the grid synchronization method of inverter using a quasi Proportional+Multi Resonant (P+MR) control-based voltage controller a stationary reference frame. The inverter supplies a non-linear load under the islanded mode. In islanded mode, the inverter is defined as a voltage source to supply the full local load demand without a connection to the grid. On the other hand, if t...

This paper presents a deadbeat-based proportional-integral (PI) controller for a stand-alone single-phase voltage source inverter using a battery cell as the primary energy source. The inverter system is simulated in MATLAB/Simulink. It consists of a lead acid battery, third-order Butterworth low-pass DC filter and AC filter, H-bridge inverter, step-up transformer, and a variety of loads, as we...

In this paper, a new topology for cascaded multilevel inverter based on quasi-Z-source converter is proposed. In the proposed topology the magnitude of output DC voltage is not limited to the sum of magnitude of DC voltage sources. Moreover, the reliability of the circuit due to capability of short circuit by Z-source network is increased. The quasi-Z- source converter in different modes is ana...

This paper proposes an H-Bridge Cascaded Three phase Multilevel Inverter. The proposed three phase Cascaded Multilevel Inverter makes use of single DC source. The proposed three phase Multilevel Inverter uses series connected three phase transformers so the number of single phase transformers used in traditional three phase Multilevel Inverter can be reduced. Hence the volume of the circuit is ...

This paper presents the performance investigation of multi-phase voltage source inverter (VSI) with simple PWM switching techniques namely the harmonic injection and offset injection method. The technique discussed in this paper is easy to implement and avoid complicated controlling algorithm adapted in SVPWM technique. A generalized algorithm suitable for odd number of phases is developed in M...