As an important problem in forging factories, dies are destroyed because of high wear rate, plastic deformation and thermal and mechanical fatigue at high temperatures. This paper is an investigation into        the use of nickel super alloy with different welding parameters. Three weld overlaid alloys of inconel625, as wear resistance hardfacing materials on H13 tool steel, with different weld...

ti-6al-4v titanium alloy has great application in medicine and military industries due to its capabilities, namely high strength to weight ratio and corrosion resistance. in the current research, the effect of aging treatment on microstructure and wear behavior of ti-6al-4v titanium alloy was investigated. pin on disk wear test was applied to assess the wear behavior. specimens were first solut...

In this work, artificial neural networks (ANNs) technique was used in the prediction of abrasive wear rate of Cu–Al2O3 nanocomposite materials. The abrasive wear rates obtained from series of wear tests were used in the formation of the data sets of the ANN. The inputs to the network are load, sliding speed, and alumina volume fraction. Correlation coefficients between the experimental data and...

Wear of Poly (Methyl MethAcrylate), PMMA, against a metallic surface, AISI 316L stainless steel, SS, has been investigated in dry conditions. These materials have been used to simulate the degradation of the contact, femoral stem-bone cement in the field of hip prosthesis. First of all, no significant wear was observed on the 316L SS. PMMA wear has been quantified: the energy wear coefficient, ...

Cross-linked polyethylenes are being introduced widely in acetabular cups in hip prostheses as a strategy to reduce the incidence of wear debris-induced osteolysis. It will be many years before substantial clinical data can be collected on the wear of these new materials. Silane cross-linked polyethylene (XLPE) was introduced into clinical practice in a limited series of acetabular cups in 1986...

The popularity of composite materials usage is increasing due to its superior strength characters racing the traditional materials in strength to weight ratio. The developments of new materials are on the anvil and are growing day by day. In this work, two-body abrasive wear test with different loads and abrading distances were performed at room temperature by using a pin on a disk apparatus to...

Electric Discharge Machining is a non-conventional machining process, used to machining difficult to machine materials. The major problem faced while doing EDM is high tool wear rate, end wear, corner wear , surface roughness and low material removal rate,. In this research work experimental investigations have been made to find the machining characteristics of high density ultra fine graphite ...

INTRODUCTION The aim of this study was to assess the wear resistance of four bulk-fill composite resin restorative materials cured using high- and low-intensity lights. MATERIALS AND METHODS Twenty-four samples were prepared from each composite resin material (Tetric N-Ceram, SonicFill, Smart Dentin Replacement, Filtek Bulk-Fill) resulting in a total of 96 samples; they were placed into a mol...