The wire scanners are used for a measurement of the very small beam size and the emittance in Accelerator Test Facility (ATF). They are installed in the extraction beam line of ATF damping ring. The extracted beam emittance are εx=1.3x10 m.rad, εy=1.7x10 m.rad with 2x10 electrons/bunch intensity and 1.3GeV energy[1]. The wire scanners scan the beam by a tungsten wire with beam repetition 0.78Hz...

This paper describes algorithms and software for decomposing CAD models for a new mold manufacturing process called WirePATHe, which uses wire electrical discharge machining (EDM) to reduce mold fabrication time. A decomposition strategy has been developed to account for the limitations of wire EDM. During decomposition, CAD models are separated into manufacturable segments and then layered if ...

OBJECTIVE To analyze the natural exit of the wire guides in major trochanter through retrograde femoral approach, in cadaver specimens. MATERIAL AND METHOD 100 femurs had been perforated between the femoral condyles, at 1.2 cm of the intercondylar region. A 3-mm straight wire guide was introduced, through retrograde approach, until the proximal extremity of femur was reached. Femurs were asse...

We generalize the bosonization methods for systems in the half line that we discussed elsewhere, to study the effects of interactions on electronic systems coupled to impurities. We introduce a model for a quantum wire coupled with a quantum dot by a purely capacitive interaction. We show that the effect on the quantum wire is a dynamical boundary condition which reflects the charge fluctuation...

the micro wire electrical discharge machining (micro wire-edm) process is a modern machining process with various applications in manufacturing micro-parts. the recast layer remaining on the machined surfaces is an inevitable complication of this process. this layer can subsequently affect the machined parts performance. to optimize the recast layer in the micro wire-edm of the molybdenum micro...

We present the construction and performance of a 20-μL active volume probe that utilizes zero-susceptibility wire for the detection transceiver coil and a 3.5 mm outer diameter thin-wall bubble flow cell to contain the sample. The probe shows good rf homogeneity, resolution, line shape and sensitivity. The sensitivity and resolution of the 20-μL probe was compared to those for several other coi...

Abstrac t -A new technique is proposed to locate wire faults and identify wire network topology using impedance spectroscopy (IS). The propagation along the cables is analytical, modelled with flexible multi section cascading features utilizing frequency dependent scattering parameters. Therefore, it doesn’t have the common numerical method problems. The transmission line model has the same spe...

The size and length effects of an inclusion on multi-pass copper shaped-wire drawing were investigated. For this purpose, an experimental investigation on optimal die half-angle was conducted. Based on experimental data of optimal die half-angle, wire and inclusion deformations, drawing and hydrostatic stress of copper shaped-wires that contain an inclusion were calculated by two-dimensional fi...

We investigate the electronic transport in a quantum wire with localized Rashba interaction. The Rashba field forms quasibound states that couple to the continuum states with an opposite spin direction. The presence of this Rashba dot causes Fano-like antiresonances and dips in the wire’s linear conductance. The Fano line shape arises from the interference between the direct transmission channe...

We present a Built-In Self-Test (BIST)-based diagnostic approach for the programmable interconnect resources in Field Programmable Gate Arrays (FPGAs) that can be used for either on-line or off-line testing. The technique was originally intended for on-line diagnosis of faulty interconnect to support fault-tolerant applications. However, the technique has been proven to be an excellent approach...