A flow cytometer using a solid state light source and detector was designed and built. For illumination of the sample stream two types of diode lasers (670 nm and 780 nm) were tested in a set-up designed to differentiate human leukocytes by means of light scattering. The detector is an avalanche photodiode, which was used to detect the weak scattered light in the orthogonal direction. The new f...

We report measurements of eeects of 2.1 MeV and 40 MeV protons on Charge Coupled Device X-ray detectors of a type soon to be launched on several astronomical research satellites. We discuss ground performance characterization techniques and compare our measurements to simple models of the detector damage mechanism. We predict detector peformance degradation rates in low-earth orbit. We plan to ...

In high dynamic conditions, using vector tracking loops instead of scalar tracking loops in GPS receivers is proved as an efficient method to compensate the performance. The Minimum Mean Squared Error detector as a multiuser detector is applied in the vector tracking loop for more reliability and efficiency. The Kalman filter does the two tasks of tracking and extracting the navigation data aft...

The development of solid-state quantum technologies requires the understanding of quantum measurements in interacting, non-isolated quantum systems. In general, a permanent coupling of detectors to a quantum system leads to memory effects that have to be taken into account in interpreting the measurement results. We analyze a generic setup of two detectors coupled to a quantum system and derive...

This paper describes a technique that combines ideas of phase shifting interferometry (PSI) and two-wavelength interferometry (TWLI) to extend the phase measurement range of conventional single-wavelength PSI. To verify theoretical predictions, experiments have been performed using a solid-state linear detector array to measure 1-D surface heights. Problems associated with TWLPSI and the experi...

In this work, the empirical parameterization describing the alpha particles’ track depth in CR-39 detectors is extended to describe longitudinal track profiles against etching time for protons and alpha particles. MATLAB based software is developed for this purpose. The software calculates and plots the depth, diameter, range, residual range, saturation time, and etch rate versus etching time. ...

We analyze the dynamics of a continuously observed, damped, microwave-driven solid state charge qubit, consisting of a single electron in a double well potential. The microwave field induces transitions between the qubit eigenstates, which have a profound effect on the detector output current. Useful information about the qubit dynamics, such as dephasing and relaxation rates, and the Rabi freq...

Microstructured optical fibers containing alkali halide scintillation materials of CsI(Na), CsI(Tl), and NaI(Tl) are presented. The scintillation materials are grown inside the microstructured fibers using a modified BridgmanStockbarger technique. The x-ray photon counts of these fibers, with and without an aluminum film coating are compared to the output of a collimated CdTe solid state detect...

Measurements using the LR 115 solid-state nuclear track detector (SSNTD) depend critically on the removed thickness of the active layer during etching, which cannot be controlled by the etching period alone. For example, the bulk etch rate depends significantly on the strength of stirring during etching. We propose here a fast, inexpensive and nondestructive method based on a color commercial d...