This article aims to investigate the influence of different contact conditions on friction properties an Nb-stabilized AISI 430 ferritic stainless-steel sheet with deep drawing quality. Three tribological tests were performed: pin-on-disk, bending under tension, and strip-tension test. Moreover, counter samples a hard metal (WC-12%Co) surface finishes 0.27 0.54 ?m used in dry lubricated conditi...

the mechanical properties and microstructural developments of 321 stainless steel during thermomechanicalprocess were investigated. the repetitive cold rolling and subsequent annealing wereconducted to achieve nanocrystalline structure in an aisi 321 stainless steel. heavily cold rolling at−20°c was conducted to form martensite in metastable austenitic steel. the process was followed byannealin...

The present work has been carried out to study the sensitization behavior of AISI 304L austenitic stainless steel weld, fabricated using GTAW (gas tungsten arc welding process). This weld was subjected to post weld thermal aging (PWTA) treatments lying in the sensitization range, viz. 700 ?C for 30 minutes, 500 minutes and 1000 minutes for studying the influence of carbide precipitation on thei...

Electrochemical noise data is commonly used to monitor corrosion of metals in various environments. In this work we use recurrence plots to study electrochemical noise time series of stainless steel AISI 316 samples immersed in mildly corrosive electrolyte. It has been found that current and potential time series reveal different information. Recurrence quantification analysis of current time s...

The Atraumatic Amniocentesis needle is manufactured by TSK Laboratory, Japan (Tochigi-Shi, Tochigi-Keri, 328 Japan). It is a 22 gauge, 90 mm needle. It has a pencil point tip with two circular holes at the tip. It is composed of a stainless steel AISI 304 with a polycarbonate hub. OD – 0.70±0.01 mm. ID – 0.40±0. 01 mm. Obturator length – 109.5±2 mm. OD of the obturator – 0.35±0.01 mm. Location ...

Thin alumina films, deposited at 280~ by low-pressure, metal-organic, chemical-vapor deposition on stainless steel, type AISI 304, were annealed at 0.17 kPa in a nitrogen atmosphere for 2, 4, and 17 hr at 600, 700, and 800~ The effect of the annealing process on the adhesion of the thin alumina films was studied using a scanning-scratch tester, type SST-IO1, developed by Shimadzu. The best mech...

Lie symmetry method is applied to find analytic solutions of initial-boundaryvalue problems of transient conduction in semi-infinite solid with constant surface temperature or constant heat flux condition. The solutions are obtained in a manner highlighting the systematic procedure of extending the symmetry method for a PDE to investigate BVPs of the PDE. A comparative analysis of numerical and...