The purpose of this research paper is to study the tool wear and surface roughness of AISI 8620 material using coated ceramic tool by turning process. Ceramic cutting tools have outstanding material hardness, resistance to high temperatures, wear resistance, chemical stability and hot hardness. Ceramic tool with Al2O3 + TiC (golden) coating was used to investigate the surface roughness and tool...

INTRODUCTION Optimization of machining parameters is essential for improving expected outcome of any machining operation. CASE DESCRIPTION The aim of this work is to find out optimum values of machining parameters to achieve minimal surface roughness during milling operation of GFRP. DISCUSSION AND EVALUATION In this machining operation speed, depth of cut and feed rate are considered as pa...

Article history: Received January 1 2012 Received in revised format April 15 2013 Accepted April 15 2013 Available online April 15 2013 Cutting force and chip reduction coefficient is the important index of machinability as it determines the power consumption and amount of energy invested in machining actions. It is primarily influenced by process parameters like cutting speed, feed and depth o...

Controlling the process variations on the perimeter of a component to the targeted mean in milling is a huge challenge. Several factors such as spindle speed, feed rate, depth of cut, etc. affects this process variation. In this paper, spindle speed and feed rate are considered. Aluminum alloy 6061 widely used materials in aircraft, automobile and helicopter components is selected for this stud...

In this paper, based on feedback linearization control method and using a special PI (propotational integrator) regulator (IP) in combination with a feed-forward controller, a three-phase induction servo-drive is speed controlled. First, an observer is employed to estimate the rotor d and q axis flux components. Then, two input-output state variables are introduced to control the dynamics of to...

a random block experiment 4×4 with sixteen diets containing four level of protein (35, 40, 45 and 50%) at four carbohydrate to lipid level (1.7, 1.4, .1 and 0.8 ) were designed to research about the ability of utilization of different levels of protein and carbohydrate to lipid ratios diet for juvenile huso huso ( 5.4 ± 0.2, mean sd )in fourteen weeks. fish fed 2-3% of body weight at each day. ...

In turning process, engineers are often faced with the problems of relating the cutting parameters (Speed, feed, depth of cut) to the output responses(Feed force, Thrust force, Cutting force, Surface roughness) to optimize the process. Also, Turing is done with the aim of achieving the best surface finish. But without optimization, it is not possible to automate the process. Turning process inv...

The legs of a future generation of hexapedal robots should enable highly articulated walking as well as robust running within the same platform. Following a hypothesis from biology [2], robustness and stability of walking mainly result from feedback control while being anchored in selfstabilizing properties of the feedforward driven mechanical structure in case of running. The advantage of this...

This paper presented a new grinding method in relation to the focus of high-speed precision machining for non-circular parts. We designed and integrated a set of grinder NC system, refitted an experimental NC grinder and researched into the control core of the NC grinder-open Programmable Multi-Axis Controller (PMAC), linear motor feed unit and high-speed electrical spindle unit. The numerical ...