This work introduces the concept of time-frequency map of the phase difference between the cantilever response signal and the driving signal, calculated with a wavelet cross-correlation technique. The wavelet cross-correlation quantifies the common power and the relative phase between the response of the cantilever and the exciting driver, yielding "instantaneous" information on the driver-resp...

The photodiode sensitivity in the atomic force microscope is calibrated by relating the voltage noise to the thermal fluctuations of the cantilever angle. The method accounts for the ratio of the thermal fluctuations measured in the fundamental vibration mode to the total, and also for the tilt and extended tip of the cantilever. The method is noncontact and is suitable for soft or deformable s...

This paper presents Cantion’s cantilever-based bio/chemical sensor. The cantilevers have integrated readout and can be used both in liquids and gases. The sensing principle is based on a cantilever bending due to a change in surface stress. Such surface-stress change is obtained during molecular interaction which has made it possible to measure DNA hybridization, antigen-antibody interactions e...

This clinical report describes a treatment for the replacement of a missing mandibular anterior tooth using a cantilever single-retainer resin-bonded fixed partial denture (RBFPD), fabricated from zirconium dioxide (ZrO2) ceramic. No clinical complications were observed at the 2-year 6-month follow-up examination after placement of the ZrO2 ceramic RBFPD, and satisfactory functional and estheti...

We cool the fundamental mode of a miniature cantilever by capacitively coupling it to a driven rf resonant circuit. Cooling results from the rf capacitive force, which is phase shifted relative to the cantilever motion. We demonstrate the technique by cooling a 7 kHz cantilever from room temperature to 45 K, obtaining reasonable agreement with a model for the cooling, damping, and frequency shi...

We present an optical technique to detect cantilever deflection of an array using Fraunhofer diffraction patterns. Application areas include probe-based data storage. Intensity profiles of different cantilever arrays are captured on a CCD camera and compared with our model. These measurements are in excellent agreement with the Fraunhofer theory, less than 3% deviation is found. Each cantilever...

The efficient cooling of nanomechanical resonators is essential to exploration of quantum properties of the macroscopic or mesoscopic systems. We propose such a laser-cooling scheme for a nanomechanical cantilever, which works even for the low-frequency mechanical mode and under weak cooling lasers. The cantilever is coupled by a diamond nitrogen-vacancy center under a strong magnetic field gra...

A self-compensating fiber optic flow sensor system based on the principle of broadband white-light interferometers and cantilever beam bending is described. The fiber optic sensor system uses two fiber ferrule sensors that are bonded on either side of a cantilever beam to measure the flow rate by monitoring the air-gap changes caused by the bending of the cantilever beam. Cross sensitivity of t...

A method to determine the spring constant of a rectangular atomic force microscope cantilever is proposed that relies solely on the measurement of the resonant frequency and quality factor of the cantilever in fluid ~typically air!, and knowledge of its plan view dimensions. This method gives very good accuracy and improves upon the previous formulation by Sader et al. @Rev. Sci. Instrum. 66, 3...

Generation of nanomechanical cantilever motion from biomolecular interactions can have wide applications, ranging from high-throughput biomolecular detection to bioactuation. Although it has been suggested that such motion is caused by changes in surface stress of a cantilever beam, the origin of the surface-stress change has so far not been elucidated. By using DNA hybridization experiments, w...