in this study, the strain rate effect on the bending properties of fiber reinforced composites for three types of polymer composites namely phenolic resin reinforced by woven basalt fibers, woven carbon fibers, and woven basalt/ woven carbon fibers at a total volume fraction of approximately 35% has been determined. flexural tests have been conducted at low range of strain rates included 0.03 m...

Thermo-set based composites using epoxy resin systems currently dominate the composite industry. Glass-reinforced epoxy composites are extensively used in the structural composites of aircraft industry due to low shrinkage, ease of fabrication, chemical resistance, and higher mechanical and electrical properties. The above characteristics coupled with techno-economic considerations are mainly r...

The use of agriculture residues as filler in composites is increasing due to their strength, abundance and low cost. Soya stalks show promising renewable natural fiber. In polyethylene composites the physical and mechanical properties (flexural resistance, tensile, impacted absorbed energy, water uptake and thickness swelling) was examined at different composites. The results showed that, the m...

To develop more green polymer composites and further know the performance of green composites, the composites based on green poly(L-lactic acid) (PLLA) and starch were fabricated by a counter-rotating mixer. And effect of starch on the fluidity and nucleating performance of PLLA was investigated using melt index instrument, optical depolarizer and wide angle X-ray diffraction instrument, respec...

Polycrystalline ceramic/single-walled carbon nanotube (SWNT) composites possess unique grain boundaries, containing 1D tortuous SWNTs bundles that form 2D tangled embedded nets. This unprecedented grain-boundary structure allows tailoring of multifunctional ceramic/SWNTs composites with unique combinations of desirable mechanical (toughness, strength, creep) and transport (electrical, thermal) ...

Different volume fractions (1.3, 2.6, and 7.6 Vol.%) of carbon nanotubes (CNTs) were dispersed within 8Y-TZP nanopowders. Mixed powder specimens were subsequently processed by spark plasma sintering (SPS) and effects of CNTs on the sintering process of 8Y-TZP/CNT composites was studied. Maintenance of CNTs through the SPS process was confirmed using TEM and Raman Spectroscopy. Studies on the si...

In this research, quasi-static penetration and ballistic properties of non-woven kenaf fibres/Kevlar epoxy hybrid laminates with thicknesses ranging from 3.1 mm to 10.8 mm by hard projectile at normal incidence have been experimentally investigated. Hybrid composites were fabricated by hand lay-up technique in a mould and cured at room temperature for 24 h by static load. Hybrid composites cons...

OBJECTIVES To test the null hypotheses that photoactive resin composites containing a Type I photoinitiator would exhibit reduced DC or increased monomer elution at substantially short curing times compared with materials based on a Type 2 ketone/amine system. METHODS Two experimental resin composites were prepared, using either Lucirin-TPO or camphorquinone/DMAEMA. Specimens were light-cured...

Thermo-set based composites using epoxy resin systems currently dominate the composite industry. Glass-reinforced epoxy composites are extensively used in the structural composites of aircraft industry due to low shrinkage, ease of fabrication, chemical resistance, and higher mechanical and electrical properties. The above characteristics coupled with techno-economic considerations are mainly r...

Thermo-set based composites using epoxy resin systems currently dominate the composite industry. Glass-reinforced epoxy composites are extensively used in the structural composites of aircraft industry due to low shrinkage, ease of fabrication, chemical resistance, and higher mechanical and electrical properties. The above characteristics coupled with techno-economic considerations are mainly r...