Unequal flaws are widespread in rock engineering, which the extensions induced by excavation and unloading main factors leading to engineering instability. Rock deformation failure essentially results of energy transmission. In order study influence flaw type angle on mechanical properties characteristics flawed mass, uniaxial compression tests were conducted using particle flow numerical analy...

http://dx.doi.org/10.1016/j.actamat.2015.07.022 1359-6454/ 2015 Acta Materialia Inc. Published by Elsevier Ltd. All rights reserved. ⇑ Corresponding author at: Department of Materials Science & Engineering, University of California, Berkeley, CA 94720, USA. E-mail address: [email protected] (R.O. Ritchie). 1 Intrinsic toughening mechanisms operate ahead of the crack tip to resistance to microst...

In an earlier paper it was suggested that a knowledge of the elastic-stress variation in the neighborhood of an angular corner of an infinite plate would perhaps be of value in analyzing the stress distribution at the base of a V-notch. As a part of a more general study, the specific case of a zero-angle notch, or crack, was carried out to supplement results obtained by other investigators. Thi...

existence of cracks in industrial structures is one of the important causes of their failure, especially when they are subjected to important axial compressive forces that might lead to buckling. therefore, it must be considered in stress analysis and designing and loading of such structures. in this paper, the buckling and post-buckling behaviors of stainless-steel cracked plates under axial c...

A B S T R A C T Using a model of a single layered foundation to describe a highway or an airfield pavement and an integral formulation, the problem of a pavement containing on-the-top layer a crack of finite length 2c is solved for the stress distribution around the crack tip. The analysis shows that the stresses possess the usual 1/e 1⁄2 singular behavior which is characteristic of crack probl...

The fracture and crack growth of mechanical structures is a usual phenomenon which is due to the application of tensile, cyclic loading or thermal stresses on the structure. So introducing of methods to prevent the crack growth is useful. Afterward, one of the repairing methods of crack growth, consisting to make a hole in the crack tip to elimi-nate the sharp corners, was explained. This metho...

In this work, repaired crack in 6061T6 aluminum plate with composite patches presented, firstly we determine the displacement, strain and stress, also the first six mode shape of the plate, secondly we took the same model adding central crack initiation, which is located in the center of the plate, its seize vary from 20 mm to 60 mm and we compare the first results with second. Thirdly we repai...

Numerical aspects of the grain level micromechanical model presented in part I are discussed in this study. They include, an examination of solution convergence in the context of cohesive elements used as an approach to model crack initiation and propagation; performance of parametric studies to assess the role of grain boundary strength and toughness, and their stochasticity, on damage initiat...

Successful in-situ monitoring of crack initiation and growth is a necessary prerequisite for applying ultrasonic methods to structural health monitoring. For conventional ultrasonic testing methods, a focused beam may be used to directly image the crack tip; however, this method is difficult to apply during fatigue testing because of access limitations and couplant contamination issues. However...