We report correlated measurements of cyclic loading behavior with electrical resistance of energystoring carbon nanotube (CNT) springs under tensile loading. Tests are conducted on fibers of MWCNTs fabricated from 6 mm tall forests. The highest measured strength and stiffness of the fibers are 0.5 N/tex and 24 N/tex. The resistance and stress responses of the fibers during loading to failure an...

OBJECTIVES Uniaxial, first-generation locking plates have become increasingly popular for fixation of supracondylar femur fractures. Polyaxial plates are currently available, which allow for variable-angle screw insertion; however, the biomechanical integrity of these new locking constructs is yet unproven. This study compares the mechanical stability of a conventional locking plate with that o...

A finite element model has been developed to simulate nonlinear response of piles/drilled piers under axial loading. The nonlinear stress-strain behaviors of soils are modeled via Drucker-Prager and von Mises type plasticity. A parametric study is carried out to address the influence of various factors, such as soil friction approximation, dilatancy, effect of interface element and shear streng...

this study aims to numerically investigate on the crashworthiness of thin-walled square tubes by consideration of 3-d oblique loading. in this type of loading, direction of loading is defined by using two spatial angles relative to the position of the tube. to this aim, finite element (fe) analysis is employed to simulate the loading for 8 different numerical models with different loading orien...

BACKGROUND AND PURPOSE Previous studies have shown that axial loading can narrow the spinal canal. However, the clinical significance is unclear. The purpose of this study was to determine whether the narrowing of the spinal canal with axial loading during MR imaging could influence treatment decision for spinal stenosis. METHODS Two hundred patients with clinical symptoms of spinal stenosis ...

This paper presents a method for predicting initial trajectories of propagation of two separate fatigue cracks, which are developed under two perpendicular cyclic loads with phase difference between them. Calculation of trajectories of these two initial cracks is the first step in prediction of trajectories and rate of propagation of long cracks. This problem is important for analysis of durabi...

The lateral confinement of masonry columns using composites have shown to improve their strength and ductility. Although, several research studies were focused on investigating the monotonic compression behaviour confined in past, cyclic characteristics, which are necessary for seismic dynamic analyses, not well investigated. Thus, an attempt has been made experimentally characterise under axia...

in this study, first energy absorption of axial and bending loading is considered. next, thin walled structures under oblique loading are investigated using abaqus computer simulation, where 180 different cases are simulated. simulation results of the thin walled structures under oblique loading were compared with the experimental results of nagel, and good agreement was perceived. simulation r...

INTRODUCTION Sacroiliac (SI) joint pain has become a recognized factor in low back pain. The purpose of this study was to investigate the effect of a minimally invasive surgical SI joint fusion procedure on the in vitro biomechanics of the SI joint before and after cyclic loading. METHODS SEVEN CADAVERIC SPECIMENS WERE TESTED UNDER THE FOLLOWING CONDITIONS: intact, posterior ligaments (PL) an...