Particle effects on friction and wear of 6061 aluminium (6061 AI) reinforced with silicon carbide (SIC) and alumina (AI203) particles were investigated by means of Vickers microhardness measurements and scratch tests. Unreinforced 6061 AI matrix alloy was also studied for comparison. To explore the effect of heat treatment, materials subjected to three different heat treatment conditions, i.e. ...

In order to properly model the friction and wear of elastomer materials, it is essential to understand some specific mechanical and tribological features. Mechanical characteristics of elastomer materials are different from those of metals and other relatively hard materials. Elastomers can bear large deformations, the stress-strain curves are non-linear, time and temperature dependent. When th...

A cold sprayed Al coating on S355 structural steel was processed using a laser remelting (LR). The surface and cross-section morphologies, chemical compositions, and phases of as-obtained Al coating before and after LR were analyzed using a scanning electronic microscope (SEM), energy dispersive spectrometer (EDS), and X-ray diffractometer (XRD), respectively, and their hardness was measured us...

In this study the friction, wear and surface mechanical behavior of medical-grade ultra-high molecular weight polyethylene (UHMWPE) (GUR 1050 resin) were evaluated as a function of polymer crystallinity. Crystallinity was controlled by heating UHMWPE to a temperature above its melting point and varying the hold time and cooling rates. The degree of crystallinity of the samples was evaluated usi...

In this investigation the friction and wear performance of GUR 1020 medical grade ultra-high molecular weight polyethylene (UHMWPE) polymer under dry sliding, distilled water and egg albumen lubrication conditions were evaluated. The sliding experiments were carried out on a pin-on-disc tribometer. The contact configuration used was a polymer pin on a rotating AISI 304L stainless steel disc. We...

We show that friction anisotropy is an intrinsic property of the atomic structure of Al–Ni–Co decagonal quasicrystals and not only of clean and well-ordered surfaces that can be prepared in vacuum [ J.Y. Park et al., Science 309,1354 (2005)]. Friction anisotropy is manifested in both nanometer-size contacts obtained with sharp atomic force microscope tips and macroscopic contacts produced in pi...

This paper focuses on the mathematical modeling of axial piston pump through dividing the failure development of friction pair into lubrication, mixed lubrication and abrasion. Directing to the wedge-shaped oil film between cylinder block and valve plate, the support force distribution under the temperature variance was obtained. Considering the rough peak of valve plate, the contact load model...

Transition metal nitrides like CrN and TiN are widely used in automotive applications due to their high hardness and wear resistance. Recently, we showed that a multilayer architecture of CrN and TiN, deposited using the hybrid-high power impulse magnetron sputtering (HIPIMS) and direct current magnetron sputtering (DCMS)-HIPIMS/DCMS deposition technique, results in coatings which indicate not ...

In order to further enhance tribological properties 316 Low carbon stainless steel (L SS) used on mechanical parts. CrN/TiN with DC magnetron sputtering sources was carried out on PVD 316 L SS. The micro structure of the CrN/TiN coatings were investigated by Scanning electron microscope (SEM), X-ray Diffraction (XRD) and tribology properties were investigated on a Pin on Disc friction and wear ...

Accumulative roll-bonding process (ARB) is an important severe plastic deformation technique for production of the ultrafine grained, nanostructured and nanocomposite materials in the form of plates and sheets. In the present work, this process used for manufacturing Al/SiO 2 nanocomposites by using Aluminum 1050 alloy sheets and nano sized SiO 2 particles, at ambient temperature. After 8 cycle...