Simulations of forced ignition of non-premixed laminar counterflow flames are used to study the effect of strain rate on ignition success. A one dimensional calculation is performed, using detailed methane chemical kinetics and treating the spark as an instantaneous heat release in an inert mixing layer. Ignition success depends on the mixture composition at the spark location, resulting in lea...

A Laser Induced Fluorescence technique (LIF) has been used to study the mixing behavior of two emerging streams in a T-Type mixing chamber. A mixing index on the basis of digital image light intensities is calculated. It has been shown that averaging over more than 800 images leads to a stable mixing index calculation. Moreover, the effect of equal and un-equal flow rates on the mixing behavior...

micromixers are one of the most crucial components of lab-on-a-chip devices with the intention of mixing and dispersion of reagents like small molecules and particles. the challenge facing micromixers is typically insufficient mixing efficiency in basic designs, which results in longer microchannels. therefore, it is desirable to increase mixing efficiency, in order to decrease mixing length, w...

Gas mixing in a T-shape micro mixer has been simulated using the Direct Simulation Monte Carlo (DSMC) method. It is considered that the adequate mixing occurs when the mass composition of the species, CO or N2, deviates below 1 % from their equilibrium composition. The mixing coefficient is defined as the ratio of the mixing length to the main channel’s height. As the inlet Kn increases, while ...

The mixing of Newtonian and non-Newtonian fluids in a magnetic micro-mixer was studied numerically using  ferrofluid. The mixing process was performed in a three-dimensional steady-state micro-mixer. A magnetic source was mounted at the entrance of the micro-channel to oscillate the magnetic particles. The effects of electric current, inlet velocity, size of magnetic particles, and non-Newtonia...

The adsorption performances of compound adsorbent (the mixing of activated carbon and CaCl2 by proper technology)-ammonia are studied, which shows the obviously improvement for long term stable operation of adsorption/desorption, and also the large adsorption cooling density. A multifunction heat pipe for heat transfer design in adsorber is invented to use waste heat for heating and sea water f...

It is now well-known that chaotic advection in laminar flow significantly impacts scalar transport – heat, mass and residence time distribution (RTD). In context of twisted pipes, such phenomena are relevant to a wide range of applications which demand rapid heat and mass transport ranging from microfluidics and continuous chemical processing to bioreactors. A general theoretical framework link...

The addition of mist to a flow of steam or gas offers enhanced cooling for many applications, including cooling of gas turbine blades. The enhancement mechanisms include effects of mixing of mist with the gas phase and effects of evaporation of the droplets. An impinging mist flow is attractive for study because the impact velocity is relatively high and predictable. Water droplets, less than 1...