Enhancement of heat transfers in counterflow plate heat exchanger due to presence of an intermediate auxiliary fluid flow is investigated. The intermediate auxiliary channel is supported by transverse conducting pins. The momentum and energy equations for the primary fluids are solved numerically and validated against a derived approximate analytical solution. A parametric study including the e...

this paper presents a comprehensive theoretical, experimental, and economic study on the application of nanofluids as heat transfer fluid in waste heat recovery systems. the research work was conducted in a steel-making complex in which a plate heat exchanger had been used to recover heat from hot process water. the system was theoretically modelled and the effects of using nanofluids as heat t...

In this paper, a fuzzy model-based algorithm is developed for leak detection in a pilot heat exchanger. A dynamic fuzzy model is first derived from input-output measurements using a fuzzy clustering technique. This model is run in parallel to the process for residual generation. The detection scheme has been tested and validated using real data from a co-current heat exchanger, and has proven t...

Research results have identified the use of heat pipe heat exchangers (HPHXs) for heat recovery as a way to reduce the pre-cooling and re-heating energy. This paper suggests decoupling dehumidification from cooling to reduce energy consumption. The feasible usage and the energy saving potential of heat pipe heat exchanger at the air handler dedicated in accomplishing this objective is investiga...

an experimental database is compiled in order to fingerprint the scales formed over the hot surfaces of heat exchangers, in cooling water systems or other systems with similar chemistry. to collect these data, a dynamic simulating pilot plant was designed with considerable application flexibility among which simultaneous flow of water with different velocity and heat fluxes to three simulating ...

the propose of this paper is to introduce a new model for crude oil fouling in preheat trains of crude distillation unit. the experimental results of australian light crude oil with the tube side surface temperatures between 200-260 oc and fluid velocity ranged 0.25 to 0.4m/s were used. the activation energy of chemical reaction depends on the surface temperature has been calculated.  the model...

for energy saving retrofit projects, its economics are usually evaluated in terms of capital investment and payback time. the capital investment is in direct relation to the total heat recovery area of the network and the payback time factor is base on both the area and the energy savings. the debottlenecking is an increased throughput, which can be profitable in economic sense. the combination...

heat and mass transfer, in this paper, is considered in one-row heat exchanger, that fins are hotter than air flow and water is added to fins. related governing equations are derived by analyzing a two-dimension model in a unique cell of a heat exchange. these equations are numerically solved by finite difference method. heat transfer and efficiency under partially wet surface are calculated by...

The calculation of Ground Heat Exchanger (GHE) performance is very important for predicting the performance and estimating the initial cost of geothermal heat pump systems. In North America it is estimated that on average GHE are oversized by about 10% ~ 30%. A vertical Ground Heat Exchanger (VGHE) is most common because of its smaller environmental influence and land field requirement. This pa...

An intermittent noise that occurs around 30 seconds after compressor start-up has been disturbing customers of many domestic refrigerator manufacturers over the past 10 years. This noise is very similar to that produced by popcorn popping, being referred to as popping noise. The most probable cause of this strange and unpleasant noise is thought to be CIS (Condensation Induced Shock). The aim o...